Related Experiment Video
Updated: Apr 21, 2026

An Inertial Measurement Unit Based Method to Estimate Hip and Knee Joint Kinematics in Team Sport Athletes on the Field
Published on: May 26, 2020
Unified modeling of pelvic transverse rotations across walking, jogging, running, and sprinting using a
Maede Alavikia1, Ahmad Reza Arshi1
1Department of Biomechanics, Faculty of Biomedical Engineering, Amirkabir University of Technology, Tehran, Iran.
Abstract:
This study investigated transverse pelvis rotations across walking, jogging, running, and sprinting using minimal limit cycle (MLC) modeling. Ten soccer players performed four gaits while a sacrum-mounted inertial measurement unit (IMU) recorded kinematics. We hypothesized that one expression could capture control mechanisms across gaits. A unified MLC model described all gait types within a common dynamical structure, with differences explained by coefficient modulation rather than distinct control strategies. Nonlinearity decreased from walking to sprinting, consistent with energetic differences between pendulum-like walking and spring-mass running dynamics. Stiffness coefficients (linear and nonlinear) varied significantly: linear stiffness was higher in sprinting than walking and jogging, while nonlinear stiffness was reduced in sprinting compared to jogging. These adaptations suggest gait-specific modulation of pelvis rotational velocity within an overarching shared framework, consistent with (but not directly demonstrating) central pattern generator (CPG)-based control architecture. Damping coefficients showed less sensitivity across gaits. Nonlinear stiffness (Duffing) and damping (Van der Pol) coefficients were consistent with stabilization mechanisms related to momentum preservation and energy recycling. Model fit improved from ∼63% in walking to ∼93% in sprinting, without changing equation structure, highlighting parameter modulation as the key mechanism. Quantifying gait transitions with a single pelvis sensor supports field-based monitoring, rehabilitation, and movement-quality screening related to injury risk, while informing bipedal robotics and rehabilitation devices requiring unified control architectures. To our knowledge, this is the first study to report unified gait modeling across four gait types using MLC with a single sensor, underscoring translational value in biomechanics, clinical practice, and robotics.
More Related Videos
07:43In Vivo Quantification of Hip Arthrokinematics during Dynamic Weight-bearing Activities using Dual Fluoroscopy
Published on: July 2, 2021
06:35Using Gold-standard Gait Analysis Methods to Assess Experience Effects on Lower-limb Mechanics During Moderate High-heeled Jogging and Running
Published on: September 14, 2017
Related Concept Videos
Relative Motion Analysis using Rotating Axes
However, to express the relative position of point B relative to point A, an additional frame of reference, denoted as x'y', is necessary. This additional frame not only translates but also rotates relative to the fixed frame, making it...
Relative Motion Analysis using Rotating Axes - Acceleration
Time differentiation is...
Absolute Motion Analysis- General Plane Motion
As the drone's propellers rotate, an upward force is generated that counteracts the force of gravity, enabling the drone to lift off from the ground. This initial movement of the drone is along a straight path, representing a form of translational motion. In this phase, every point on the...
Relative Motion Analysis using Rotating Axes-Problem Solving
Here, in order to determine the magnitude of velocity and acceleration for point...