Related Experiment Video
Updated: Apr 28, 2026

Façade-Level Monitoring of CO2 Variability under Urban Heat Island Conditions using Low-Cost Sensor Data Loggers
Published on: December 12, 2025
Deep learning-based thermal mapping for enhanced urban heat management and cooling energy reduction in Arid Saudi
Abdulaziz Mislat Alsharif1, Abdulrahman Mubarak Almajadiah2, Mohammed Alzahrani1
1Department of Architecture, College of Architecture and Planning, Qassim University, Buraidah, 52571, Saudi Arabia.
Abstract:
Urban energy consumption in arid regions presents substantial challenges for sustainable development, with cooling demands representing a major component of building energy loads. The urban heat island (UHI) phenomenon intensifies these pressures by raising surrounding air temperatures, which in turn amplifies cooling needs. Robust energy management approaches depend on precise representation of land surface temperature (LST) at spatial scales fine enough to distinguish individual buildings and infrastructure, although practical thermal mapping systems are constrained by fundamental trade-offs between spatial resolution and temporal frequency. Although deep learning (DL) methods have shown promise for enhancing the resolution of thermal imagery, prior research has largely focused on temperate regions, resulting in limited insight into thermal behavior in arid and semi-arid urban environments. This study addresses this limitation by adapting DeepLabV3 + architecture for LST super-resolution in Saudi Arabian cities. The model incorporates atrous spatial pyramid pooling to capture multi-scale thermal patterns and employs specialized feature-fusion modules designed to preserve thermal boundaries at building edges and vegetation interfaces. The training data consisted of spatially aligned Landsat 8 thermal images and high-resolution UAV-based thermal observations collected over representative urban forms in Riyadh and Medina, allowing assessment of the model's spatial transferability across contrasting climatic regimes. Model accuracy achieved RMSEs below 1.5 °C in Riyadh and Medina, validating building-scale thermal assessments. The results indicate that vegetation and high-albedo surfaces play a substantial role in lowering LSTs. The resulting building-scale thermal products facilitate energy audits, cooling-demand mitigation, targeted retrofit prioritization, and energy-efficient urban planning in arid regions.
More Related Videos
06:43Esophageal Heat Transfer for Patient Temperature Control and Targeted Temperature Management
Published on: November 21, 2017
10:36Author Spotlight: Optimization of Airflow Velocities in Battery Cooling Systems for Enhanced Thermal Performance and Reduced Energy Consumption
Published on: November 3, 2023
Related Concept Videos
Heating and Cooling Curves
For instance, the addition of heat raises the temperature of a solid; the amount of heat absorbed depends on the heat capacity of the solid (q = mcsolidΔT). According to thermochemistry, the relation between the amount of heat absorbed or released by a substance,...
Quantifying Heat
Mechanisms of Heat Transfer II
Thermal Stress
Mechanisms of Heat Transfer
Conduction, accounting for approximately 3% of body heat loss at rest, is the process of exchanging heat between molecules of two materials in direct contact. This can result in both heat loss and gain. For instance, when the body is submerged in water, which conducts heat 20 times more effectively than air, it can either lose or gain significant...
Mechanisms of Heat Transfer I