Biofilm Formation Patterns of S. epidermidis (RP62A) and S. aureus (UAMS-1) Are Defined by Orthopaedic Implant...

Background/Objectives:Staphylococcus epidermidis (RP62A) and Staphylococcus aureus (UAMS-1) are clinically relevant pathogens frequently implicated in implant-associated infections due to their ability to form biofilms. RP62A is typically linked to persistent, chronic, low-grade infections, whereas UAMS-1 is associated with acute, invasive disease. Both strains serve as representative models for chronic and acute periprosthetic joint infections (PJIs). The objective of this study was to examine and compare in vitro biofilm formation by RP62A and UAMS-1 on orthopaedic materials/disc surfaces of defined composition. Methods: In vitro biofilm formation assays were performed using orthopaedic disc surfaces composed of cobalt-chromium alloy (CoCr), titanium alloy (Ti), and polyethylene (PE) after 72 h of incubation. Biofilm biomass was quantified using crystal violet staining, with absorbance measured at OD₅₇₀. A polystyrene (PS) surface served as a control. Additionally, retrieved orthopaedic explant components were used as substrates for in vitro biofilm assays, in which RP62A was incubated for 72 h on the explanted surfaces. Supporting assays on glass slides were conducted to examine strain-specific biofilm-related architecture. Results: In vitro biofilm mass quantification assays showed strong biofilm formation by RP62A across all tested surfaces, with the highest absorbance on CoCr (OD₅₇₀ = 5.80 ± 0.19). Notably, biofilm formation on CoCr was 76% higher compared to PS (p < 0.0001). No significant differences were observed among all three surface discs (p > 0.1). Biofilm formation was highest on PE for UAMS-1 (OD₅₇₀ = 1.29 ± 0.09) and was significantly greater than on Ti (178%, p < 0.001) and CoCr (196%, p < 0.0001). In the in vitro assays performed on retrieved explant components, RP62A showed pronounced biofilm accumulation on polyethylene tibial inserts, particularly in regions of mechanical wear and friction. Supporting assays on glass slides were performed to examine strain-specific surface microstructural, revealing dense network-like structures for RP62A and thinner, discontinuous layers for UAMS-1. Conclusions: RP62A formed dense biofilms in vitro on multiple orthopaedic implant materials and retrieved explant components, consistent with its association with chronic periprosthetic joint infections. Increased biofilm accumulation was observed on mechanically worn polyethylene surfaces. In contrast, UAMS-1 showed lower biofilm formation on metallic disc surfaces, indicating strain- and material-dependent differences. These findings highlight the relevance of implant material selection and surface integrity for strategies targeting biofilm-associated implant infections.