A Novel Pressure-Assisted Induction Melting Technique for Synthesis of Lightweight High-Entropy Alloys: A Concept,...

Lightweight high-entropy alloys are primarily designed to overcome the strength-to-density ratio limitations of conventional counterparts and often consist of elements with drastically different melting temperature and vapor pressure. Their chemistry, therefore, imposes challenges on alloy synthesis, particularly through liquid metal engineering routes, since elements with high vapor pressure (e.g., Mg, Zn, Li) vaporize before the higher-melting-point ingredients (e.g., Cu, V, Ni) are fully molten, resulting in volatile element loss. To overcome this challenge, a novel pressure-assisted induction melting (PAIM) process was developed and the proprietary furnace for its implementation was designed and built. The system allows precision melting of up to 10 cm³ of an alloy at temperatures up to 1700 °C while addressing the partial pressure requirements during the melting progress. The chamber is prepared using rough vacuum and re-filled with inert gas such as argon with the operating pressure range from about 10^-4 MPa up to maximum of 1.6 MPa (233 psi). The alloy chemical composition can be modified in situ by feeding solid additives at specific melting stages through the isolated airlock without disrupting the pressure conditions within the chamber. The viability of the concept was verified by synthesis of two lightweight non-equimolar high-entropy alloys: Mg-rich Mg₅₀(MnAlZnCu)₅₀ and Al-rich Al₃₅Mg₃₀Si₁₃Zn₁₀Y₇Ca₅. The experiments showed that sequential multi-step melting procedures, designed based on inputs from FactSage computational analysis, when combined with PAIM synthesis, allowed manufacturing fully dense and chemically homogenous complex alloy compositions with optimal volumes for materials discovery research.