FPGA Implementation of a Radar-Based Fall Detection System Using Binarized Convolutional Neural Networks

As the number of elderly individuals living alone increases, the risk of fall-related accidents correspondingly rises, underscoring the need for rapid fall detection systems. Because falls are difficult to predict in terms of location, detection systems must be deployed in a distributed manner, which in turn requires compact and low-power implementations. Unlike camera sensors, radar sensors do not raise privacy concerns and are not limited by line-of-sight constraints. Moreover, compared with wearable sensors, radar enables continuous monitoring without user intervention. However, prior radar-based approaches incur high computational complexity, leading to increased power consumption and larger hardware area, thereby necessitating efficient hardware design. This paper proposes a lightweight fall detection system based on continuous-wave (CW) radar and a binarized convolutional neural network (BCNN). Radar signals are preprocessed using short-time Fourier transform (STFT) to generate binary spectrograms, which are then fed into a BCNN-based classification network. The proposed system performs binary classification of five fall activities and seven non-fall activities with an accuracy of 96.1%. The preprocessing module and classification network were implemented as hardware accelerators and integrated with a microprocessor in a system-on-chip (SoC) architecture on a field-programmable gate array (FPGA). Compared with the software implementation, the proposed hardware achieved speedups of 387.5× and 86.7× for the preprocessing and classification modules, respectively. Furthermore, the overall system processing time was 2.58 ms, corresponding to an 89.5× speedup over the software baseline.