Related Experiment Video
Updated: May 15, 2026

3D Kinematic Gait Analysis for Preclinical Studies in Rodents
Published on: August 3, 2019
Comparison of Plug-in Gait and CGM2.3 models reveals systematic differences in joint kinematics and kinetics
Tom Thiel1,2, Anu M Valtonen2,3, Juha-Pekka Kulmala4,5
1Faculty of Sport and Health Sciences, Neuromuscular Research Center, University of Jyväskylä, Jyväskylä, Finland.
Abstract:
This study compared two widely used biomechanical models-Plug-in Gait (PiG) and Conventional Gait Model 2.3 (CGM2.3)-during overground walking (WALK) and single-leg squats (SLS) in 24 healthy adults. Data was collected using a 20-camera Vicon system and force plates. Static trials were analyzed with medial knee and ankle markers to align joint axes across models. Kinematic and kinetic outputs were compared using root mean square differences (RMSD) and statistical parametric mapping (SPM) paired t-tests. During WALK, PiG produced greater internal rotation at the knee (RMSD 17.8°, p < 0.001) and hip (RMSD 5.0°, p < 0.001), and smaller sagittal-plane flexion angles (RMSD 2.6° knee, 2.3° hip) compared with CGM2.3. In single-leg squats, these discrepancies increased to 29.1° and 9.0°, respectively, with sagittal-plane differences of 4.4° at the knee and 5.1° at the hip. CGM2.3 yielded higher knee flexion moments (31% in WALK, 104% in SLS), while PiG produced higher frontal-plane knee moments (28% and 89%). The differences were most pronounced at deeper flexion angles. These results demonstrate that biomechanical outcomes differ systematically between models, emphasizing the impact of model selection on joint kinematics and kinetics in human movement analysis.
Related Concept Videos
Structural Classification of Joints
A fibrous joint is where the adjacent bones are united by fibrous connective...
Kinematic Equations - II
Suppose a car merges into freeway traffic on a 200 m long ramp. If its initial velocity is 10 m/s and it accelerates at 2 m/s2, then the...
Kinematic Equations - III
Using the kinematic equations,...
Kinematic Equations - I
Kinematic Equations: Problem Solving
Functional Classification of Joints
The functional classification of joints is determined by the amount of mobility between the adjacent bones. Joints are functionally classified as a synarthrosis or immobile joint, an amphiarthrosis or slightly moveable joint, or as a diarthrosis, a freely moveable joint. Fibrous and cartilaginous joints can be functionally classified as either synarthroses or amphiarthroses, whereas all synovial joints are classified as diarthroses.
Synarthrosis
An immobile...
