Electrostatic Gating of Ionic Conductance through Heterogeneous van der Waals Nanopores

Nanofluidic ionic transistors typically require gate voltages above 1 V and operate only at submillimolar ionic strengths, limiting their biocompatible applications. We demonstrate ionic transistors consisting of single sub-10 nm nanopores drilled in van der Waals (vdW) heterostructures with internal gate electrodes made of few-layer graphene. These devices deliver up to 10-fold current modulation at gate voltages as low as 0.3 V in 10 mM KCl, and ∼2-fold modulation at near-physiological 100 mM KCl. Baseline conductance with no gate shows surface-charge-dominated transport below 100 mM KCl, consistent with negatively charged hBN walls and ∼5 nm opening of the pores. The surface charge and the electrochemical asymmetry introduced by the three-electrode configuration govern the device's behavior: negative gate voltage (V_G) enriches ionic concentrations and enhances current, whereas positive V_G induces a local depletion zone that suppresses transport. The current modulation by V_G is dependent on the polarity of the transmembrane potential and leads to ion current rectification. Molecular dynamics simulations of a nanopore in a hBN-graphene-hBN stack reveal confinement and surface charge-dependent suppression of the relative permittivity of interfacial water. Continuum modeling with radially varying interfacial water permittivity reproduces the asymmetric I-V characteristics and explains how the embedded gate sculpts local potential and ion concentrations. By enabling sub-0.5 V control of ionic transport at up to 100 mM salt concentrations, these devices address a key need in nanofluidics to create low-power ionic circuits and biosensing.