Related Experiment Video

Updated: Jun 14, 2026

Measurements of Waves in a Wind-wave Tank Under Steady and Time-varying Wind Forcing
08:54

Measurements of Waves in a Wind-wave Tank Under Steady and Time-varying Wind Forcing

Published on: February 13, 2018

Development and operation of a 100 W wave energy converter for persistent ocean observation

Curtis J Rusch1, Erik Hammagren2, Joe Prudell2

  • 1University of Washington Applied Physics Laboratory, Seattle, WA, 98105, USA. curusch@uw.edu.

Scientific Reports
|June 12, 2026
PubMed
Abstract

More Related Videos

Large Scale Energy Efficient Sensor Network Routing Using a Quantum Processor Unit05:30

Large Scale Energy Efficient Sensor Network Routing Using a Quantum Processor Unit

Published on: September 8, 2023

Related Concept Videos

Energy and Power of a Wave00:58

Energy and Power of a Wave

The total energy associated with a wavelength is the sum of the potential energy and the kinetic energy. The average rate of energy transfer associated with a wave is called its power, which is total energy divided by the time it takes to transfer the energy. For a sinusoidal wave, energy and power are proportional to the square of both the amplitude and the angular frequency.
Waves can also be concentrated or spread out, as characterized by the intensity of the wave. Intensity is directly...
Propagation of Waves01:07

Propagation of Waves

When a wave propagates from one medium to another, part of it may get reflected in the first medium, and part of it may get transmitted to the second medium. In such a case, the interface of the two mediums can be considered as a boundary that is neither fixed nor free.
Consider a scenario where a wave propagates from a string of low linear mass density to a string of high linear mass density. In such a case, the reflected wave is out of phase with respect to the incident wave, however the...
Kinetic and Potential Energy of a Wave01:10

Kinetic and Potential Energy of a Wave

All forms of waves carry energy; this is directly visualized in nature. For instance, the waves of earthquakes are so intense that they can shake huge concrete buildings, causing them to fall. Loud sounds can damage nerve cells in the inner ear, causing permanent hearing loss. The waves of the oceans can erode beaches. 
In mechanical waves, the amount of energy is related to their amplitude and frequency. In the context of the above examples, large-amplitude earthquakes produce large ground...
Wave Parameters01:10

Wave Parameters

The simplest mechanical waves are associated with simple harmonic motion and repeat themselves for several cycles. These simple harmonic waves can be modeled using a combination of sine and cosine functions. Consider a simplified surface water wave that moves across the water's surface. Unlike complex ocean waves, in surface water waves, water moves vertically, oscillating up and down, whereas the disturbance of the wave moves horizontally through the medium. If a seagull is floating on the...
Full wave rectifier01:22

Full wave rectifier

A full-wave rectifier is a device that converts alternating current (AC) to direct current (DC) and is more efficient than its half-wave counterpart. It typically includes a center-tapped transformer, two diodes, and a load resistor. The secondary winding of the transformer is divided to provide two equal voltages of opposite polarities, which is the pivotal element of full-wave rectification.
Standing Waves01:17

Standing Waves

Sometimes waves do not seem to move; rather, they just vibrate in place. Unmoving waves can be seen on the surface of a glass of milk kept in a refrigerator, which is one example of standing waves. Vibrations from the refrigerator motor create waves on the milk that oscillate up and down but do not seem to move across the surface. These waves are formed or created by the superposition of two or more identical moving waves in opposite directions. The waves move through each other, with their...