Related Experiment Video
Updated: Jun 20, 2026

Preparing Silica Aerogel Monoliths via a Rapid Supercritical Extraction Method
Published on: February 28, 2014
Measuring the principle Hugoniot of low-density silica aerogel foam at pressures up to 160 GPa
Jordan Lee1, Peter Norreys1, Robert Paddock2
1University of Oxford, Clarendon Laboratory, Department of Physics, Atomic and Laser Physics sub-Department, Parks Road, Oxford OX1 3PU, United Kingdom.
Abstract:
Low-density foams are of significant interest in inertial confinement fusion (ICF), with potential applications as fuel carriers, ablation layers, or as a hohlraum filling material. Despite their potential, the shock response of these materials remains poorly characterized, limiting the accuracy of hydrodynamic simulations. Here we report experimental measurements of the equation of state for 90mg/cm^{3} silica (SiO_{2}) aerogel foam under laser-driven shock compression, conducted at the GEKKO XII laser facility. Shock pressures between 50 and 160 GPa were achieved, and the corresponding states were determined using standard impedance-matching techniques with a quartz reference material. Initial measurements appeared to underestimate the foam shock velocity relative to predictions by the Quotidian Equation of State (QEOS) model. Experimental diagnostics indicated the presence of a vacuum gap between the reference material and the foam. The vacuum gaps were characterized, and one-dimensional radiation-hydrodynamic simulations were conducted to estimate their impact on the measured shock velocity. After applying simulation-based corrections, the experimental Hugoniot aligns closely with QEOS predictions, supporting the model's applicability to low-density foams.
More Related Videos
Related Concept Videos
Measurement of Fluid Pressure
A basic form of manometer is the piezometer, a vertical tube open at the top and filled with the same...
Specific Gravity of Aggregate
Bulk or gross specific gravity is calculated by taking the ratio of the mass of aggregates in the saturated surface-dry state to the total volume that includes both the solids and the voids within the...
Density, Specific Weight, Specific Gravity and Compressibility of Fluid
Specific weight represents the weight per unit volume and is calculated by multiplying density...
Pressure of Fluids
Molecular Weight of Step-Growth Polymers
As the step-growth polymerization involves step-wise condensation of monomers, the molecular weight also builds up eventually. Consequently, high molecular weight polymers are obtained at the late stages of the polymerization, where 99% of monomers have been consumed.
The extent of the...
Measurement of Air Content in Concrete
The pressure method,...

