Related Experiment Video
Updated: Jun 23, 2026

Subsurface Defect Localization by Structured Heating Using Laser Projected Photothermal Thermography
Published on: May 15, 2017
Lateral distribution of electrical defect concentration in SA TG coplanar IGZO TFTs extracted via low frequency noise
Dong-Ho Lee1, Jin-Ha Hwang1, Chae-Eun Oh1
1Major in Intelligent Semiconductor Engineering, Chung-Ang University, 84 Heukseok-ro, Dongjak-gu, Seoul, Korea.
Abstract:
This study presents a methodology for extracting the lateral distribution of electrical defect concentration (NB) associated with gate-insulator traps contributing to low-frequency noise (LFN) of self-aligned top-gate (SA TG) coplanar indium-gallium-zinc oxide (IGZO) thin-film transistors (TFTs) using low-frequency noise (LFN) analysis. The proposed approach utilizes modulation of the effective channel length by drain voltage (or source voltage) together with an LFN power spectral density model to obtain the average defect concentration corresponding to different effective channel lengths, from which the lateral defect distribution can be derived. The extracted results reveal that pristine devices exhibit a relatively uniform defect distribution along the channel with slightly higher values near the source and drain regions. After the application of saturation stress, a noticeable increase in the defect concentration is observed near the drain side of the channel, indicating localized degradation of the gate insulator. These findings demonstrate that LFN analysis can be used to experimentally probe the spatial distribution of gate-insulator defects in SA TG coplanar IGZO TFTs, providing a useful diagnostic approach for studying reliability degradation mechanisms in advanced display backplane devices.
Related Concept Videos
Bode Plots Construction
Electrostatic Boundary Conditions in Dielectrics
Consider a case where both the mediums across a boundary are two different dielectric materials. Recall that the electric field and electric displacement are proportional and related through the material's permittivity.
Fault Types
For line-to-line faults occurring between phases B and C, the...
