Microstructure Characteristics and Tribological Performances of LPBF-Processed TiC_p/TA15 Composite

The microstructural characteristics and precipitate features of titanium matrix composites (TMCs) are critical to tribological performance. In this study, TiCp/TA15 composites were fabricated via laser powder bed fusion (LPBF). The as-built composite was then heat-treated at 750 °C for 2 h to obtain a uniform duplex (α + β) microstructure with enhanced TiC precipitation, which was labeled as HT-750. The influence of the microstructural evolution on the tribological performance was systematically investigated. Compared to the as-built composite, the HT-750 composite exhibited a microhardness increase from 360.2 ± 6.4 HV to 459.2 ± 3.1 HV, a reduction in the friction coefficient from 0.649 ± 0.167 to 0.581 ± 0.111, and a decrease in the wear rate from 8.24 ± 0.44 × 10^-4 mm³/(N·m) to 4.81 ± 0.39 × 10^-4 mm³/(N·m), indicating a significant enhancement in wear resistance. This improvement is primarily attributed to the synergistic strengthening effect of the duplex matrix and TiC particles, which enhanced the load-bearing capability and suppressed surface plastic deformation. During the friction process, the dominant wear mechanisms of as-built and HT-750 composites evolved over time but exhibited distinct differences. The as-built composites were prone to continuous plastic deformation and damage accumulation, resulting in severe delamination, oxidative, and abrasive wear. Conversely, the HT-750 composites demonstrated higher resistance to plastic deformation and crack propagation, effectively mitigating interfacial shear and inhibiting damage evolution, with the wear mechanism being dominated by oxidative wear accompanied by abrasive wear and minor delamination. This work provides deep insights into the wear mechanisms of additively manufactured TMCs.