Related Experiment Video
Updated: Jul 3, 2026
3D Planning and Printing of Patient Specific Implants for Reconstruction of Bony Defects
Published on: August 4, 2020
Construction of a 3D printed, human gingival MSC seeded alveolar bone implant
Hilal Selamet1,2, Seyma Isik1,3, Deniz Yucel1,4,5
1Biomaterials Center, Acibadem University, Atasehir, Istanbul, Türkiye.
Abstract:
Background/objective(s)/introduction:Tissue engineered scaffolds fabricated by 3D printing promises to enhance the success rate in alveolar bone augmentation. The aim of this study was to construct and characterize a 3D printed poly(ε-caprolactone; PCL) scaffolds treated with bone morphogenetic protein 2 (BMP-2) and carrying human gingival mesenchymal stem cells (hGMSCs) for potential use in the augmentation of alveolar bone.
Materials And Methods:
PCL scaffolds with defined pore geometry were fabricated by 3D printing using fused deposition modeling (FDM) and treated with O2 plasma to enhance BMP-2 and cell adhesion. The scaffolds were characterized by compression testing, scanning electron microscopy (SEM), and water contact angle measurement. BMP-2 was bound to the surface, and hGMSCs from gingival connective tissue were seeded onto the scaffolds. BMP-2 was quantified by elisa. The cells were identified as stem cells based on their differentiation capacity and immunophenotypic profile. Osteogenic differentiation on BMP-2 bound scaffolds was assessed using alkaline phosphatase (ALP) activity and calcium deposition assays.
Results:
Compressive modulus of the PCL scaffolds (73.2 ± 17.1 MPa) was close to human alveolar bone (96.2 ± 40.6 MPa). SEM revealed a porous design with continuous struts, creating an average pore size of 400 µm and zig-zag channels suitable for cell infiltration and adhesion. O2 plasma treatment decreased the water contact angle from 110° ± 4° to 59° ± 2°, indicating improved surface hydrophilicity. ELISA showed that over 98% of BMP-2 remained bound to the scaffold for 28 days, indicating prolonged growth factor presence during cell culture. Within the environment created, BMP-2 bound scaffolds led to a threefold increase in ALP activity and higher calcium deposition compared to controls, confirming enhanced osteogenic differentiation.
Conclusion(S):
3D printed PCL scaffolds functionalized with BMP-2 and seeded with hGMSCs exhibited highly improved in vitro osteogenic properties which promises to improve alveolar bone augmentation results.
