Water-specific toxicity factor and index for heavy metal risk assessment: application to urban lakes in Chennai,

Daniel Rosado1,2,3, Indumathi Nambi4, Nicola Fohrer5

  • 1Department of Hydrology and Water Resources Management, Institute for Natural Resource Conservation, Kiel University, Olshausenstr. 75, 24118, Kiel, Germany. drosado@hydrology.uni-kiel.de.

Related Concept Videos

The Periodic Table and Organismal Elements01:27

The Periodic Table and Organismal Elements

Elements are the smallest units of matter that cannot be broken down further by chemical processes. There are 118 known elements, but not all of these are naturally occurring, and only a few of them are essential for life. Living matter is composed primarily of carbon, nitrogen, hydrogen, and oxygen, with smaller amounts of other elements like calcium, phosphorus, potassium, and sulfur. Other elements are also necessary for life but only in trace amounts.
Periodic Table Provides Information...
The Periodic Table and Organismal Elements00:57

The Periodic Table and Organismal Elements

Elements are the smallest units of matter that cannot be broken down further by chemical processes. There are 118 known elements, but not all of these are naturally-occurring, and fewer still are essential for life. Living matter is composed primarily of carbon, nitrogen, hydrogen, and oxygen, with smaller amounts of other elements like calcium, phosphorus, potassium, and sulfur. Other elements are also necessary for life but only in trace amounts.The Periodic Table Provides Information about...
Quality of Water01:19

Quality of Water

In concrete preparation, the quality of water is paramount as it affects the strength and durability of the concrete. Potable water is usually preferred; however, it must not have excessive sodium or potassium to prevent compromising the concrete's integrity. Water quality is typically evaluated based on impurities such as dissolved solids, chlorides, and sulfates, and its pH value is ideally between 6 and 8. Even slightly acidic natural water may be acceptable unless it contains harmful...
Testing Water Quality01:14

Testing Water Quality

When the quality of water for concrete preparation is uncertain, its impact on the setting time of cement and compressive strength of mortar is assessed by comparison with de-ionized or distilled water benchmarks. American Society for Testing and Materials (ASTM) C1602 requires the setting times to be within 90 minutes of the control, British Standard (BS) 3146:1980 allows a 30-minute variance in the initial setting, while British Standards European Norm (BS EN) 1008 specifies initial setting...
Extraction: Advanced Methods00:56

Extraction: Advanced Methods

Metal ions can be separated from one another by complexation with organic ligands–the chelating agent– to form uncharged chelates. Here, the chelating agent must contain hydrophobic groups and behave as a weak acid, losing a proton to bind with the metal. Since most organic ligands used in this process are insoluble or undergo oxidation in the aqueous phase, the chelating agent is initially added to the organic phase and extracted into the aqueous phase. The metal-ligand complex is formed in...
Toxicity Testing in Animals01:23

Toxicity Testing in Animals

Toxicity tests in animals are grounded on two main assumptions: first, the effects observed in laboratory animals can be extrapolated to humans, especially when adjusted for body surface area; second, high-dose exposure in animals is essential to identify potential human hazards from lower doses. This is based on the quantal dose-response concept, which faces the challenge of extrapolating results from relatively few test animals to much larger human populations. For example, a 0.01% incidence...