Thermal-Input-Induced Microstructural Evolution and Mechanical Response of Mg-Gd-Y-Zn-Zr Alloy Wires During...

To reveal the influence of pulsed current density on the microstructural evolution and mechanical properties of Mg-Gd-Y-Zn-Zr rare-earth magnesium alloy wires, extruded Mg-10Gd-3.4Y-1.3Zn-0.4Zr alloy wire was selected as the research material. By regulating the current density in the range of 12-20 A/mm², the effects on temperature rise behavior, microstructural evolution, and mechanical properties were systematically investigated. The results show that as the current density increases from 12 A/mm² to 20 A/mm², the measured surface peak temperature rises from 207 °C to 497 °C, and the mechanical properties among the electropulsing-treated samples exhibit a trend of first increasing and then decreasing. Among these treated samples, the optimal combination of strength and ductility is achieved at a current density of 15 A/mm², at which the tensile strength and elongation reach 312.2 MPa and 13.6%, respectively. Microstructural analysis indicates that appropriate pulsed electrical parameters promote the dissolution, fragmentation, and homogenized dispersion of block-shaped long-period stacking ordered (LPSO) phases, thereby optimizing the internal strain state and facilitating the activation of non-basal slip. However, when the current density increases to 20 A/mm², excessive thermal input leads to grain coarsening and a network-like W-phase precipitation, indicating that excessive energy input can lead to microstructural instability and mechanical degradation.