A Comparative Review of Multi-Walled Carbon Nanotube-Reinforced Thermoplastic Petroleum-Based (PET, PBT) and...

This review comparatively analyzed MWCNT-reinforced thermoplastic polyester nanocomposites based on petroleum-derived (PET, PBT) and bio-based (PLA, PBS) matrices, focusing on processing methods, mechanical performance, thermal stability, electrical behavior, and recyclability. Optimal MWCNT loadings typically ranged from 0.3 to 3 wt.%; higher loadings induced nanotube agglomeration and deteriorated properties due to poor dispersion and stress concentration. Melt mixing, solution blending, direct compounding, and in situ polymerization were evaluated, and their influence on dispersion quality, interfacial bonding, and scalable manufacturability was discussed. PET exhibited the largest improvements in mechanical and thermal performance (tensile strength and modulus increases >300% in optimized systems); acid or compatibilizer functionalization of MWCNT improved PET thermal stability by approximately 20-50 °C and promoted heterogeneous nucleation. PBT reached optimal reinforcement at 0.3-1 wt.% MWCNT, yielding tensile strength increases up to ~57% alongside increased crystallinity and faster crystallization kinetics. PLA generally showed reduced tensile strength after MWCNT addition unless compatibilized (e.g., via plasticizers or grafting), whereas PBS consistently gained strength, modulus, and crystallinity but experienced reductions in ductility. Electrical percolation thresholds varied widely (0.25-14 wt.%), demonstrating that dispersion quality, nanotube functionalization, and processing route governed conductivity and percolation behavior more than matrix chemistry. Recyclability and circular economy aspects were assessed: while PET/MWCNT systems showed promise for mechanical recycling and property recovery, data on repeated reprocessing, CNT structural integrity, and long-term electrical performance were scarce; PBT recycling studies were limited, and PBS/PLA recycling with retained conductive networks remained underexplored. Based on the comparative analysis, key limitations, critical research gaps, and practical recommendations for processing, compatibilization, and end-of-life evaluation were identified to guide future work aimed at enhancing both performance and sustainability of polyester/MWCNT nanocomposites.