Related Experiment Video
Updated: Aug 13, 2026
Three-Dimensional Preoperative Virtual Planning in Derotational Proximal Femoral Osteotomy
Published on: February 17, 2023
Improving surgical planning for patients with deep endometriosis using patient specific 3D anatomical models: A
Carly M Cooke1, Teresa E Flaxman2, Shauna Duigenan3
1University of Ottawa, Faculty of Medicine, Department of Obstetrics and Gynecology, Ottawa, Ontario, Canada.
Objective:
To evaluate the clinical impact of incorporating patient specific 3-dimensional (3D) printed anatomical models into gynecological practice for improving surgical planning and patient outcomes in patients with deep endometriosis.
Methods:
A pilot prospective randomized control study using a repeated measure, questionnaire-based design included patients consented for surgical excision of endometriosis. Patients were randomized to have a 3D printed model or not (control). 3D models were rendered from T2 weighted magnetic resonance images. Gynecologic surgeons completed questionnaires on surgical planning, surgical outcomes and surgeon experience before and after viewing the 3D printed models and post-operatively and comparisons were made using paired t tests.
Results:
There were 5 patients included in the 3D printing group and 8 patients in the control group. In the 3D printing group, there was a change in 5/10(50%) surgeon responses for perception of surgical level of difficulty, 5/10(50%) surgeon responses for allotted surgical time, and 3/10(30%) surgeon responses for estimated blood loss after viewing the 3D model. Eight of 10(80%) of surgeon responses reported referencing the model intraoperatively. Allotted surgical time was significantly greater post viewing compared to pre-viewing the model (256.4±60.5 vs. 246.4±56.6 minutes; d = -0.19, P = 0.044) and estimated blood loss significantly lower post-viewing compared to pre-viewing the model (177.3±114.8 vs. 204.6±154.1 ml; d = 0.293, P = 0.003). Compared to control cases, mean surgical time was significantly lower in the 3D model cases (271.7±94.6 vs. 460±225.2mins; P = 0.006).
Conclusions:
3D printed models may help to optimize surgical planning and improve surgical performance, bettering the overall surgical outcomes in gynecologic surgery for deep endometriosis.
