Retraction notice to "Analysis of HFE impact of COVID-19 on OHS in construction enterprises" [Heliyon 11 (2025) e41275]

Consider the elastic torsion formula, which applies to a circular shaft with a consistent cross-section. This formula assumes that the shaft's ends are loaded with rigid plates firmly attached. However, in many cases, torques are applied to the shaft through mechanisms like flange couplings or gears, which are connected by keys inserted into keyways. This application method modifies the stress distribution near the point of torque application, causing it to deviate from the distributions...

Hazard Analysis and Critical Control Points (HACCP) is a science-based, preventive system used globally to ensure food safety by identifying, evaluating, and controlling biological, chemical, and physical hazards throughout food production. Originally developed by NASA and the Pillsbury Company for astronaut food, HACCP is now a core component of the Codex Alimentarius.HACCP operates on prerequisite programs—such as Good Manufacturing Practices (GMPs), sanitation procedures, and supplier...

Essential infection prevention measures are based on the knowledge of the infection chain, the modes of transmission in healthcare settings, and the use of the best practices in all healthcare settings. Compulsory public reporting of healthcare-associated infection rates is needed to allow individuals and the community to make informed choices regarding selecting a healthcare facility.
The best practices for preventing healthcare-associated infections include hand hygiene, patient risk...

When designing or analyzing a structural member, it is important to consider the internal loadings developed within the member. These internal loadings include normal force, shear force, and bending moment. Engineers can ensure that the structural member can support the applied external forces by calculating these internal loadings.
To illustrate this, let's consider a beam OC of 5 kN, inclined at an angle of 53.13° with the horizontal and supported at both ends. Determine the internal loadings...

Stress concentration is when stress intensifies near discontinuities such as holes or abrupt cross-sectional changes in a structural member. This localized stress can often surpass the average stress within the member. The stress distribution in flat bars, either with a circular hole or varying widths connected by fillets, can be determined experimentally using a photoelastic method. The results are based on ratios of geometric parameters like the ratio of the hole's radius to the smaller width...

The concept of stress concentration is crucial for understanding how materials respond under bending stresses, particularly when there are irregularities or discontinuities in the material's geometry. Normally, stress in a symmetric member subjected to pure bending is assumed to be uniformly distributed across the entire cross-section. However, this assumption does not hold when there are variations in the cross-sectional geometry or the presence of notches and holes.
The stress concentration...