Finite-Time Thermodynamics of Battery Discharging: Power-Efficiency Trade-Off and Optimization

Rui-Han Liu1, Yun-Qian Lin1, Yu-Han Ma1,2

  • 1School of Physics and Astronomy, Beijing Normal University, Beijing 100875, China.

Related Concept Videos

The Carnot Cycle01:30

The Carnot Cycle

Converting work to heat is an irreversible process, and the purpose of a heat engine is to reverse the effect partially. Heat engines aim to increase the efficiency of the reversal, that is, maximize the work retrieved from heat. If the efficiency of a heat engine were 100%, it would imply reversing the process completely without introducing any other effect. Thus, it would violate the second law of thermodynamics.
What could be the theoretical limit to the efficiency of a heat engine? The...
Maximum Power Transfer01:16

Maximum Power Transfer

Numerous practical applications within engineering disciplines, such as telecommunications, necessitate optimizing power delivery to a connected load. This pursuit, however, entails inherent internal losses, which can either equal or exceed the power supplied to the load. The Thevenin equivalent circuit is helpful in finding the maximum power a linear circuit can deliver to a load. It is assumed in this context that the load resistance can be adjusted.
By substituting the entire circuit with...
Carnot Cycle and Efficiency01:26

Carnot Cycle and Efficiency

The Second Law of Thermodynamics asserts that it's impossible for any heat engine to achieve 100% efficiency. While contemplating the maximum possible efficiency, Nicolas Sadi Carnot conceptualized an ideal heat engine. This engine gets its energy from a high-temperature reservoir. It then performs some work and releases the remaining energy into a low-temperature reservoir.The Carnot cycle, named after Sadi Carnot, is fully reversible. The cycle consists of four distinct stages. In the first...
Power Dissipated in a Circuit: Problem Solving01:15

Power Dissipated in a Circuit: Problem Solving

The equivalent resistance of a combination of resistors depends on their values and how they are connected.
The simplest combinations of resistors are series and parallel connections. In a series circuit, the first resistor's output current flows into the second resistor's input; therefore, each resistor's current is the same. Thus, the equivalent resistance is the algebraic sum of the resistances. The current through the circuit can be found from Ohm's law and is equal to the battery's emf...
RC Circuits: Discharging A Capacitor01:27

RC Circuits: Discharging A Capacitor

One of the applications of an RC circuit is the relaxation oscillator. The relaxation oscillator comprises a voltage source, a capacitor, a resistor, and a neon lamp. The lamp acts like an open circuit (infinite resistance) until the potential difference across the neon lamp reaches a specific voltage. At that voltage, the lamp acts like a short circuit (zero resistance), and the capacitor discharges through the neon lamp and produces light. Once the capacitor is fully discharged through the...
Energy Stored in a Capacitor: Problem Solving01:26

Energy Stored in a Capacitor: Problem Solving

In 1749, Benjamin Franklin coined the word battery for a series of capacitors connected to store energy. Capacitors store electric potential energy that can be released over a short time. This property means capacitors have a wide range of applications.
Capacitor-discharge ignition is a type of ignition system commonly found in small engines where the energy released from a capacitor ignites an induction coil that, in turn, fires the spark plug.
To calculate the energy stored in a capacitor of...