Related Experiment Video
Updated: Aug 28, 2026

On the Preparation and Testing of Fuel Cell Catalysts Using the Thin Film Rotating Disk Electrode Method
Published on: March 16, 2018
Parameter Decoupling and Standardization of an RDE Protocol for CO Tolerance Evaluation of the Alkaline Hydrogen
Hong-Fei Xing1, Mei-Li Wang1, Hao-Ran Wu1
1College of Materials Science and Engineering, Zhengzhou University, Zhengzhou 450001, China.
Abstract:
CO poisoning remains a major challenge for hydrogen fuel cells, and rotating disk electrode (RDE) measurements are widely used for preliminary screening of CO-tolerant catalysts. However, variations in key testing parameters, including catalyst loading, CO exposure time, and linear sweep voltammetry (LSV) scan rate, can substantially affect the apparent CO tolerance response and compromise cross-study comparability. Here, Pt/C was employed as a model catalyst to systematically decouple the effects of these parameters on CO tolerance evaluation of the hydrogen oxidation reaction (HOR). Catalyst loading was identified as a critical factor: at a low Pt loading of 5 μgPt cm-2, CO adsorption caused a severe decrease in the HOR limiting current, whereas at a high loading of 40 μgPt cm-2, excess available Pt sites markedly diluted the apparent poisoning effect. Electrochemical impedance analysis further revealed distinct loading-dependent changes in interfacial charge-transfer and mass-transport processes under CO-containing conditions. In addition, prolonged CO pre-exposure increased surface poisoning and current loss, while slower LSV scanning amplified the apparent poisoning response by extending the effective CO exposure time. Based on these findings, we propose a standardized RDE evaluation principle based on low catalyst loading, sufficient CO pre-exposure, and slow potential scanning, providing a more reproducible and comparable benchmark for evaluating catalyst-dependent resistance to CO poisoning under controlled RDE conditions.
Related Concept Videos
Reduction of Alkenes: Asymmetric Catalytic Hydrogenation
The metal catalyst used can be either heterogeneous or homogeneous. When hydrogenation of an alkene generates a chiral center, a pair of enantiomeric products is expected to form. However, an enantiomeric excess of one of the products can be facilitated using an enantioselective reaction or an...
Oxidation of Alkenes: Syn Dihydroxylation with Osmium Tetraoxide
Reduction of Alkenes: Catalytic Hydrogenation
Metals like palladium, platinum, and nickel are commonly used in their solid forms — fine powder on an inert surface. As these catalysts remain insoluble in the reaction mixture, they are referred to as heterogeneous catalysts.
The hydrogenation process takes place on the surface of...
Alcohols from Carbonyl Compounds: Reduction
Catalytic hydrogenation is similar to the reduction of an alkene or alkyne by adding H2 across the pi bond in the presence of transition metal catalysts like Raney Ni, Pd–C, Pt, or Ru. Aldehydes and ketones can be reduced by this method, often under mild to moderate heat (25–100°C) and...
Vicinal Diols via Reductive Coupling of Aldehydes or Ketones: Pinacol Coupling Overview
Aldol Condensation with β-Diesters: Knoevenagel Condensation

