Related Experiment Videos

A three-term conjugate gradient method with a new descent structure for unconstrained optimization and low-carbon

Maulana Malik1,2, Sulaiman Mohammed Ibrahim3,4, Dian Lestari1,2

  • 1Department of Mathematics, Faculty of Mathematics and Natural Sciences, Universitas Indonesia, Depok, Indonesia.

Plos One
|August 27, 2026
PubMed

Related Concept Videos

Lagrange Multipliers: Two Constraints01:28

Lagrange Multipliers: Two Constraints

The method of Lagrange multipliers with two constraints is used to optimize a function subject to two independent constraints. In many applications, the objective function represents a quantity to be maximized or minimized, such as cost, area, distance, or energy. The two constraints represent requirements that the solution must satisfy, such as fixed volume, limited resources, or prescribed dimensions.For a function of three variables, each constraint forms a surface in three-dimensional space.
Maximizing the Directional Derivative01:25

Maximizing the Directional Derivative

The directional derivative is a central concept in multivariable calculus that describes how a function changes at a given point when moving in a specified direction. This direction is represented by a unit vector, ensuring that only the orientation influences the rate of change. By varying the direction, different rates of change can be observed, demonstrating that the directional derivative depends strongly on the chosen direction.The directional derivative is computed using the gradient...
Lagrange Multipliers: One Constraint01:29

Lagrange Multipliers: One Constraint

In constrained optimization, the objective is to maximize or minimize a quantity while satisfying a fixed condition. A standard example is a rectangular pen built against a barn wall using 100 meters of fencing. Because the wall provides one side of the enclosure, only the other three sides require fencing. The problem is to find the dimensions that produce the greatest possible area.Let L represent the length parallel to the wall and W the width perpendicular to it. The area of the pen is A =...
Methods of Medium Optimization01:28

Methods of Medium Optimization

Optimizing growth media enhances microbial proliferation and maximizes product yield. Statistical experimental design methodologies provide structured and reproducible approaches, offering progressively higher levels of robustness and efficiency.The One-Factor-at-a-Time (OFAT) MethodThe One-Factor-at-a-Time (OFAT) method involves adjusting a single variable while keeping all others constant. However, it cannot detect interactions between variables, often leading to suboptimal outcomes when...
Lagrange Multipliers: Problem Solving01:30

Lagrange Multipliers: Problem Solving

A silo with a cylindrical base, flat bottom, and hemispherical roof is a common design in agricultural and industrial storage due to its structural efficiency and ease of construction. Optimizing its dimensions to maximize storage capacity for a given amount of material—i.e., a fixed surface area—is a classic problem in applied calculus and engineering design. The key parameters are the radius r of the base and the height h of the cylindrical section.The total volume of the silo is obtained by...
Design of Transmission Shafts01:16

Design of Transmission Shafts

The design of a transmission shaft is governed by two primary specifications: the power it transmits and its rotational speed. These parameters guide the selection of the shaft's material and cross-sectional dimensions, ensuring that the material's maximum shearing stress remains within the elastic limit while transmitting the desired power at the given speed. The system's power is intrinsically linked to the applied torque. The torque applied to the shaft can be calculated by reconfiguring the...