Related Experiment Video
Updated: Sep 4, 2026

A Fabrication and Measurement Method for a Flexible Ferroelectric Element Based on Van Der Waals Heteroepitaxy
Published on: April 8, 2018
A family of ultrathin non-van der waals kamiokite-type oxides for two-dimensional electronics
Run Shi1, Yonghuang Wu1,2, Liang Zhou3
1State Key Laboratory of New Ceramic Materials, Tsinghua University, Beijing, China.
Abstract:
Non-van der Waals (vdW) two-dimensional (2D) metal oxides provide an opportunity to enrich the current 2D material library and accelerate the adoption of 2D materials into future electronic devices. However, the exploration of 2D non-vdW oxides remains limited, constrained by synthetic challenges and insufficient fundamental understanding. Here, we report a 2D wide-bandgap non-vdW oxide family-A2Mo3O8 (A = Zn, Mn, Co, etc.), known as kamiokite-type oxides. A dual-controlled chemical vapor deposition strategy enables the in-plane growth of ultrathin A2Mo3O8 single crystals with thicknesses below 3 nm and domain sizes exceeding 100 μm, overcoming the intrinsic constraints of lattice isotropy while providing facile and precise control over product stoichiometry. Notably, 2D Zn2Mo3O8 exhibits a bandgap of 4.0 eV and a high dielectric constant (κ ~ 25). Benefiting from the good dielectric properties and high-quality interface of Zn2Mo3O8, MoS2 transistors with a Zn2Mo3O8 top-gate dielectric exhibit near-Boltzmann-limit subthreshold swing (~63.8 mV dec-1), an on/off ratio exceeding 107, and an ultralow hysteresis width of 1.6 mV MV-1 cm under ambient conditions. The A2Mo3O8 family offers a versatile materials platform for the development of high‑κ dielectrics and a broad range of functional components for next-generation high-performance 2D electronics.
Related Concept Videos
Types of Semiconductors
Non-ohmic Devices
Consider a simple circuit consisting of a battery, a diode, and a resistor. A diode...
Metal-Semiconductor Junctions
Schottky Barriers
Schottky barriers arise when a metal with a work function (Φm) contacts a semiconductor with a different work function (Φs). Initially, electrons transfer until the Fermi levels of the metal and semiconductor align at equilibrium. For instance, if Φm > Φs, the semiconductor Fermi level is higher than the metal's before contact. The semiconductor's...
Types of Reversible Electrodes

