Colorado Braces For Impact As It Prepares To Meet H.R. 1's New Rules

Jessica Bylander1

  • 1Jessica Bylander (jbylander@projecthope.org) is a deputy editor and correspondent at Health Affairs, in Washington, D.C. This article, part of a series on the impact of H.R. 1, is being published with the support of a journalism grant from the National Institute for Health Care Management Foundation.

Related Concept Videos

Standards of Care II01:19

Standards of Care II

Nurses bear specific legal responsibilities under several federal statutes, including:
Hückel's Rule Diagram of π MOs: Frost Circle01:08

Hückel's Rule Diagram of π MOs: Frost Circle

The Frost circle or the inscribed polygon method is a graphical method for determining the relative energies of π molecular orbitals (MOs) for planar, fully conjugated, and monocyclic compounds. This method was first described by A. A. Frost and Boris Musulin in 1953.
A Frost circle is constructed by drawing a polygon whose number of edges is equal to the number of carbons of the given cyclic system, with one of the vertices pointing down. Then, a circle is drawn enclosing the polygon so that...
Standards of Care I01:22

Standards of Care I

Federal statutes profoundly impact nursing practice, providing critical guidelines to ensure patient care is equitable, accessible, and of the highest quality. The following laws address distinct aspects of healthcare provision and patient rights:
Kirchoff's Rules: Application01:22

Kirchoff's Rules: Application

Kirchhoff's rules quantify the current flowing through a circuit and the voltage variations around the loop in a circuit. Applying Kirchhoff's rules generates a set of linear equations that allow us to find the unknown values in circuits. These may be currents, voltages, or resistances.
When applying Kirchhoff's first rule, the junction rule, label the current in each branch and decide its direction. If the chosen direction is wrong, it will have the correct magnitude, although the current will...
Stress-Strain Diagram - Brittle Materials01:24

Stress-Strain Diagram - Brittle Materials

Brittle materials, including glass, cast iron, and stone, exhibit unique characteristics. They fracture without considerable change in their elongation rate, indicating that their breaking and ultimate strength are equivalent. Such materials also show lower strain levels at the point of rupture. The failure in brittle materials predominantly results from normal stresses, as evidenced by the rupture created along a surface perpendicular to the applied load. These materials do not display...
Teeth01:15

Teeth

The formation of teeth, also known as odontogenesis, is a complex process that begins in utero, around the sixth week of embryonic development. There are three stages to this process: the bud stage, the cap stage, and the bell stage.
In the bud stage, the tooth germ (an aggregation of cells) starts to form in the developing jawbone. During the cap stage, the tooth germ differentiates into enamel organ, dental papilla, and dental sac, which will later develop into the tooth's enamel, dentin and...