Related Experiment Video
Updated: Sep 11, 2026

Preoxygenation Techniques for Tracheal Intubation in Critically Ill Adults Utilizing Oxygen Mask and Noninvasive Ventilation
Published on: December 5, 2025
A randomised trial comparing 80% and 100% inspired oxygen concentrations for time to adequate preoxygenation using
G Venkata Poornima1, A Chaitanya Pratyusha2, Ch Rama Krishna Prasad2
1Department of Anaesthesia, ESIC Medical College, Hyderabad, Telangana, India.
Background And Aims:
Preoxygenation with 100% oxygen is associated with absorption atelectasis. This study compared 80% and 100% fractional inspired oxygen concentration (FiO2) for the time to achieve adequate preoxygenation, defined by end-tidal oxygen (EtO2). Secondary outcomes included the incidence of postoperative atelectasis, proportion of patients requiring more than 3 minutes for preoxygenation, haemodynamic changes, and desaturation.
Methods:
Two-hundred patients for general anaesthesia were randomly divided into either Group I or Group S, the intervention and the standard practice groups, and were preoxygenated with 80% and 100% FiO2, respectively. The time taken to reach an EtO2 of 10% below the administered FiO2 was considered the time to adequate preoxygenation. A lung ultrasonography was performed at baseline and again immediately after extubation. Independent t-test or Mann-Whitney U test and the Chi-square test were used for continuous and nominal categorical data, respectively. Non-inferiority was concluded if the lower bound of the confidence interval remained above the predefined non-inferiority margin of -15 seconds.
Results:
The median preoxygenation time was comparable between groups: 95 s [interquartile range (IQR) 70-133] and 99.5 s (IQR 80.3-140) in Group I and S, respectively (P = 0.484; 95% confidence interval -21 to 11). Non-inferiority was not demonstrated. The effect size was small (r = -0.096), indicating minimal clinical difference. However, atelectasis was significantly higher in Group S (31.9%) compared to Group I (8.6%) (P = 0.002).
Conclusion:
Non-inferiority of FiO2 80% with 100% could not be established within the prespecified margin, though the median time to achieve adequate preoxygenation was comparable.
More Related Videos
Related Concept Videos
Special considerations while measuring oxygen saturation
Ensuring accuracy in vital sign recordings while prioritizing patient comfort and minimizing anxiety is important.
Treatment for Pulmonary Arterial Hypertension: Oxygen Therapy for Respiratory Failure
Oxygen therapy is vital in increasing and maintaining blood oxygen levels in PAH patients. As a result, it aids in reducing fatigue, improving...
Oxygen Delivering System II: Venturi Mask and Transtracheal Oxygen
Venturi Mask
The Venturi mask, named after the Venturi effect, is designed to deliver precise oxygen concentrations. It consists of a large tube with an oxygen inlet that narrows down, causing a pressure drop that pulls air in through adjustable side ports. The mask is a lightweight,...
Assessment of Diffusion and Perfusion
The Role of Diffusion in Respiration
Diffusion is the process by which molecules move from an area of higher concentration to an area of lower concentration. In the respiratory system, this principle...
Administering Oxygen by Mask
Administering oxygen by mask is a common nursing intervention that provides supplemental oxygen to patients with respiratory distress or chronic lung conditions. This procedure involves delivering oxygen at a specified rate through a face mask connected to an oxygen source.
Equipment
The equipment necessary for this procedure includes:
Oxygen Delivering System I: Nasal Cannula and Face Mask
Nasal Cannula
A nasal cannula is a lightweight tube split at one end into two prongs and placed in the nostrils. It is typically used to deliver low to medium levels of oxygen.
Suggested flow rate: The suggested flow rate for a nasal cannula typically ranges between 1 and 6 L/min.
Oxygen percentage setting:...

