Related Experiment Video

Updated: Sep 12, 2026

The Effect of Construction and Demolition Waste Plastic Fractions on Wood-Polymer Composite Properties
09:06

The Effect of Construction and Demolition Waste Plastic Fractions on Wood-Polymer Composite Properties

Published on: June 7, 2020

Assessing the impact of construction material waste drivers on project cost overrun across material processing

Lobna Kamal1, Mohamed S Yamany2, Hossam E Hosny1

  • 1Department of Construction Engineering, Faculty of Engineering, Zagazig University, Zagazig, 44519, Egypt.

Scientific Reports
|September 10, 2026
PubMed

Keywords:
Construction projectsCost overrunsMaterial wastePLS-SEMStructural equation modeling

Related Concept Videos

Impact Loading01:19

Impact Loading

Impact loading occurs when a moving object collides with a stationary structure, such as a rod with a uniform cross-sectional area fixed at one end. Under these conditions, the rod absorbs the kinetic energy from the striking object, leading to deformation and subsequent stress development. As the rod returns to its original position and reaches maximum stress, the absorbed energy, initially manifested as kinetic energy, transforms entirely into strain energy.
In cases of elastic deformation,...
Design Example: Managing Concrete Workability01:14

Design Example: Managing Concrete Workability

This example deals with managing the workability of concrete for a raft foundation project under hot weather conditions. Workability is crucial for ensuring the concrete is easy to place, compact, and finish. In this scenario, a slump test — a common method to measure the workability of fresh concrete — initially indicated low workability. This was attributed to the rapid water loss from the concrete mix, exacerbated by the high temperatures causing the course aggregates to heat up.
To address...
Design Consideration01:22

Design Consideration

Designing a structure involves a series of considerations, primarily the material's ultimate strength, calculated through tests that measure changes under increased force until the material reaches its breaking point or limit. The ultimate load, where the material breaks, is divided by its original cross-sectional area, resulting in the ultimate normal stress or strength. The ultimate shearing stress is another significant factor taken into account.
The factor of safety is another key aspect...
Bending of Members Made of Several Materials01:11

Bending of Members Made of Several Materials

In analyzing a structural member composed of two different materials with identical cross-sectional areas, it is crucial to understand how their distinct elastic properties affect the member's response under load. The analysis involves assessing stress and strain distributions using the transformed section concept, which accounts for variations in material properties.
Hooke's Law determines stress in each material, stating that stress is proportional to strain but varies due to each material's...
Strategies for Assessing and Addressing Confounding01:25

Strategies for Assessing and Addressing Confounding

Confounding is a critical issue in epidemiological studies, often leading to misleading conclusions about associations between exposures and outcomes. It occurs when the relationship between the exposure and the outcome is mixed with the effects of other factors that influence the outcome. Given that, addressing confounding is of high importance for drawing accurate inferences in research.
Confounding can be addressed at both the design phase of a study and through analytical methods after data...
Method of Superposition01:20

Method of Superposition

The method of superposition is a crucial technique in structural engineering, used to analyze the effect of multiple loads on beams. This approach involves calculating the deflection and slope for each load on a beam separately, and then summing these effects to determine the overall impact. It is applicable only when the beam material remains within its elastic limit, ensuring that deformations are linearly elastic.
When applying the method of superposition, each type of load—whether...