Related Experiment Video
Updated: Sep 16, 2026

Preparation of Aligned Steel Fiber Reinforced Cementitious Composite and Its Flexural Behavior
Published on: June 27, 2018
Quince Seed and Flaxseed Mucilage as Natural Viscosity-Modifying Agents in Cementitious Composites: Rheological,
Ayşe Türk1, Furkan Türk1, Hayriye Nur Nayan1
1Civil Engineering, Konya Technical University, Konya 42250, Turkey.
Abstract:
This study evaluated the feasibility of using mucilage derived from plant seeds as a viscosity-modifying agent in cementitious composites. Mucilages derived from quince seeds (quince seed mucilage, QSM) and flax seeds (flaxseed mucilage, FSM)-which are readily available, low-cost, and sustainable sources of hydrocolloids-were dried and ground into powder, then used as viscosity-modifying agents in cementitious mixtures. Their effects on the mortars were compared with those of welan gum (WG), which is commercially used as a viscosity-modifying agent. According to the results, at a 0.1% dosage QSM and FSM reduced the spread diameter by 63% and 61% respectively, and significantly increased the V-funnel flow time, which exceeded 40 s. Rheological measurements revealed that all additives used increased viscosity, yield stress, and thixotropy. QSM increased plastic viscosity by approximately 8.9 times, and FSM by approximately 8.4 times. While the additives caused only a minor reduction in compressive strength (below 8%), they increased the resistance to segregation and extended the setting time. It was concluded that QSM and FSM can be used as viscosity-modifying agents in cement-based composites because they modulate the rheological properties without altering the mechanical properties of the mortars.
More Related Videos
07:42Quasistatic Mechanical Testing for Computer-Aided Design and Manufacturing Occlusal Veneers Cemented to Milled Dentin Analog Material
Published on: December 20, 2024
06:27Expression of Cementitious Pore Solution and the Analysis of Its Chemical Composition and Resistivity Using X-ray Fluorescence
Published on: September 23, 2018
Related Concept Videos
Additives and Fillers in Concrete
The...
Plasticizers
Plasticizers function by using surface-active agents to create repulsive electrostatic forces between cement particles. This dispersion enhances the concrete's...
Strength of Cement
For compressive strength tests, ASTM C 109-05 standards prescribe a cement-sand mix ratio of 1:2.75 and a water/cement ratio of 0.485 for making 2-inch cubes. These cubes are mixed, cast, and cured in saturated lime water at 23°C until testing. Flexural strength testing, outlined in ASTM C...
Fineness of Cement
Direct...
Superplasticizers
Pozzolans
Fly ash is a...