In-Situ Monitoring of Machining Loads and Cross-Scale Characterization of Surface Integrity and Electrochemical...

Ultrasonic vibration-assisted machining (UVAM) can improve the machinability of difficult-to-machine titanium alloys; however, the relationship between machining-load fluctuations, subsurface microstructure, and electrochemical response remains insufficiently established. In this study, a wireless in-situ monitoring system was integrated with electron backscatter diffraction (EBSD), electrochemical impedance spectroscopy (EIS), potentiodynamic polarization, and scanning electrochemical microscopy (SECM) to compare conventional milling (CM), low-excitation UVAM (L-UVAM), and high-excitation UVAM (H-UVAM) of Ti-6Al-4V. Under the investigated conditions, H-UVAM reduced the RMS value of the measured axial load signal by 43.3% compared with CM and decreased the variation in the resultant bending-moment signal. The EBSD results showed a reduction in the mean grain size from 11.67 μm for CM to 10.07 μm for H-UVAM, together with an increase in the measured high-angle grain-boundary fraction from 48.27% to 59.39%. Electrochemical measurements further indicated a lower corrosion current density and a higher fitted barrier resistance for the H-UVAM surface. SECM mapping showed a narrower local current distribution under H-UVAM than under CM. These results demonstrate a consistent association between reduced machining-load fluctuations, modified subsurface crystallographic features, and improved electrochemical response. Because surface roughness, residual stress, tool wear, and passive-film chemistry were not independently quantified, the present work does not attribute the corrosion response exclusively to microstructural changes. Instead, it provides a cross-scale experimental framework for correlating machining dynamics with surface integrity and corrosion-related performance in machined titanium alloys.