Developing the Readout Electronics for a Custom 64 × 64 SPAD Array: From Single-Board Prototyping to FPGA...

Single-photon avalanche diode (SPAD) arrays enable photon-starved applications, including time-of-flight imaging and stellar intensity interferometry. Their astronomical use remains scarcely explored, as the bottleneck is usually not detection but rather acquisition electronics for high-rate event streams. This work presents a modular, event-driven acquisition system for a 64 × 64 SPAD array within the La Palma Quantum Interferometer (LPQI) project, repurposing a LiDAR detector for multi-telescope interferometry. Two stages are used: a Raspberry Pi 5 with a custom board for validation, and an AMD Kria KR260 (Zynq UltraScale+ MPSoC) implementing the Address-Event Representation (AER) handshake in hardware at 100 MHz. The system streams AER events without per-event timestamping; sub-nanosecond time-tagging is left for a future stage based on the White Rabbit protocol. Optical bench tests confirmed spatial detection and localization of photons at a measured throughput of up to ≈124 keps under the highest illumination condition tested, and dark-count-rate characterization showed a rate below 10 Hz for most pixels (median: 1.68 Hz at 27.8 °C); raw per-pixel event-count maps further confirmed, for the first time on this array, the expected 2 × 2 spatial pattern of inter-pixel crosstalk from its shared-cathode pixel groups. The results demonstrate the feasibility of repurposing a LiDAR SPAD sensor and establish an acquisition-electronics baseline to aid the development of a timestamped, multi-telescope system for deployment on five telescopes of the Roque de los Muchachos Observatory.