Related Experiment Video
Updated: Oct 8, 2026

Ultrasonic-Assisted Preparation of Biodiesel Products from Vegetable Oils
Published on: April 19, 2024
Pomegranate peel-derived Cu/hydrochar nanocomposites: a sustainable catalyst for biodiesel production via oleic acid
Amal A Alkahlawy1, Delvin Aman2, Ahmed A Galhoum3
1Petroleum Refining Department, Egyptian Petroleum Research Institute (EPRI), 1 Ahmed El Zomour St., PO Box 11727, Nasr City, Cairo, Egypt. amal_kahlawy@yahoo.com.
Abstract:
Transforming pomegranate peel waste into a biodiesel catalyst advances waste-to-resource circularity. A facile hydrothermal carbothermal reduction method was used to synthesize copper-decorated hydrochar nanocomposites derived from peel bio-waste and CuSO4, with Cu(II) concentrations of 10, 25, and 50 mmol/L (denoted as Cu10/HC, Cu25/HC, and Cu50/HC, respectively). The physicochemical properties of the nanocomposites were characterized by FTIR, XRD, BET, XPS, SEM-EDX, and NH₃-TPD, and their catalytic performance was evaluated for biodiesel production via the esterification of oleic acid (OA) with ethanol. Structural analysis confirmed highly pure, crystalline zero-valent copper (Cu⁰) with an FCC nanostructure and spherical morphology (average size ~ 25-63 nm), well-dispersed throughout the hydrochar-derived carbon matrix. XPS verified oxygen functionalities (-COO⁻, > C = O, C-OH) alongside Cu⁰ on the nanocomposite surfaces. Moreover, textural analysis revealed that Cu25/HC exhibited the highest surface area (29.6 m²/g) and pore volume (0.099 cm³/g), whereas Cu50/HC showed reduced porosity but introduced significant acidity (54.9 µmol/g, according to NH3-TPD). Catalytic efficiency increased with higher Cu dispersion density (Cu atoms/nm2; R² =0.996): Cu50/HC achieved the best performance (97.4% conversion), followed by Cu25/HC (96.6%) and Cu10/HC (96.0%), outperforming bulk Cu content and BET surface area. Under optimal conditions (70 °C, 5 h, 1.0 wt% catalyst relative to OA, and an ethanol/OA molar ratio of 15:1) the Cu50/HC catalyst attained complete OA conversion. Thermodynamic parameters were determined and indicated an endergonic and thermodynamically non-spontaneous reaction. Notably, the catalyst retained 97.1% of its initial activity after six consecutive cycles, demonstrating excellent operational stability, as confirmed by the FTIR, XRD, and Cu content. These findings position the Cu50/HC nanocomposite as a cost-effective, sustainable, and efficient catalyst for biodiesel production.
More Related Videos
11:28Biomass Conversion to Produce Hydrocarbon Liquid Fuel Via Hot-vapor Filtered Fast Pyrolysis and Catalytic Hydrotreating
Published on: December 25, 2016
09:10Experimental Protocol for Biodiesel Production with Isolation of Alkenones as Coproducts from Commercial Isochrysis Algal Biomass
Published on: June 24, 2016
Related Concept Videos
Biofuels
Reduction of Alkenes: Asymmetric Catalytic Hydrogenation
The metal catalyst used can be either heterogeneous or homogeneous. When hydrogenation of an alkene generates a chiral center, a pair of enantiomeric products is expected to form. However, an enantiomeric excess of one of the products can be facilitated using an enantioselective reaction or an...
Bioplastics
Microbial Bioremediation of Hydrocarbons
Esters to Carboxylic Acids: Acid-Catalyzed Hydrolysis
During hydrolysis, the ester is first activated towards nucleophilic attack through the protonation of the carboxyl oxygen atom by the acid catalyst. The protonation makes the ester carbonyl carbon more electrophilic. In the next step, water acts as a nucleophile and adds to the...
Esters to Carboxylic Acids: Saponification
The reaction requires a base in stoichiometric amounts, which participates in the reaction and is not regenerated later. So, the base acts as a...