Related Experiment Videos

Fisher's combined probability test for cross-sectional independence in panel data models with serial correlation

Hongfei Wang1, Binghui Liu1, Long Feng2

  • 1Northeast Normal University.

Statistica Sinica
|October 17, 2026
PubMed

Related Concept Videos

Introduction to Test of Independence01:21

Introduction to Test of Independence

In statistics, the term independence means that one can directly obtain the probability of any event involving both variables by multiplying their individual probabilities. Tests of independence are chi-square tests involving the use of a contingency table of observed (data) values.
The test statistic for a test of independence is similar to that of a goodness-of-fit test:
Fisher's Exact Test01:08

Fisher's Exact Test

Fisher's exact test is a statistical significance test widely used to analyze 2x2 contingency tables, particularly in situations where sample sizes are small. Unlike the chi-squared test, which approximates P-values and assumes minimum expected frequencies of at least five in each cell, Fisher's exact test calculates the exact probability (P-value) of observing the data or more extreme results under the null hypothesis. This feature makes it especially valuable when the assumptions of the...
Behrens–Fisher Test00:57

Behrens–Fisher Test

The Behrens-Fisher test is a statistical method designed to address the Behrens-Fisher problem, which arises when comparing the means of two normally distributed populations with unequal variances. Unlike the Student's t-test, which assumes equal variances, the Behrens-Fisher test allows for mean comparison without this restrictive assumption. This flexibility makes it particularly valuable in scenarios where two independent samples exhibit normality but lack variance homogeneity.
This test is...
Hypothesis Test for Test of Independence01:16

Hypothesis Test for Test of Independence

The test of independence is a chi-square-based test used to determine whether two variables or factors are independent or dependent. This hypothesis test is used to examine the independence of the variables. One can construct two qualitative survey questions or experiments based on the variables in a contingency table. The goal is to see if the two variables are unrelated (independent) or related (dependent). The null and alternative hypotheses for this test are:
H0: The two variables (factors)...
Test for Homogeneity01:23

Test for Homogeneity

The goodness–of–fit test can be used to decide whether a population fits a given distribution, but it will not suffice to decide whether two populations follow the same unknown distribution. A different test, called the test for homogeneity, can be used to conclude whether two populations have the same distribution. To calculate the test statistic for a test for homogeneity, follow the same procedure as with the test of independence. The hypotheses for the test for homogeneity can be stated as...
F Distribution01:19

F Distribution

The F distribution was named after Sir Ronald Fisher, an English statistician. The F statistic is a ratio (a fraction) with two sets of degrees of freedom; one for the numerator and one for the denominator. The F distribution is derived from the Student's t distribution. The values of the F distribution are squares of the corresponding values of the t distribution. One-Way ANOVA expands the t test for comparing more than two groups. The scope of that derivation is beyond the level of this...