Related Experiment Videos

From data to carbon efficiency: Data as a production factor and corporate carbon intensity

Guixin Huang1, Juan Qian1, Yongjing Shang1

  • 1School of Economics and Management, Xinjiang University, Urumqi, 830046, China; Engineering Research Center of Northwest Energy Carbon Neutrality (ERCNECN), Ministry of Education, Urumqi, 830046, China; Institute for Macroeconomy High-Quality Development of Xinjiang, Urumqi, 830046, China.

Journal of Environmental Management
|October 23, 2026
PubMed

Keywords:
Carbon intensityData elementsEnvironmental information governanceGreen innovationResource allocation

Related Concept Videos

Production Efficiency01:01

Production Efficiency

Net production efficiency (NPE) is the efficiency at which organisms assimilate energy into biomass for the next trophic level. Due to low metabolic rates and less energy spent on thermoregulatory processes, the NPE of ectotherms (cold-blooded animals) is 10 times higher than endotherms (warm-blooded animals).
Factors Affecting Activity Coefficient01:17

Factors Affecting Activity Coefficient

The extended Debye-Hückel equation indicates that the activity coefficient of an ion in an aqueous solution at 25°C depends on three partially interdependent properties: the ionic strength of the solution, the charge of the ion, and the ion size. 
The activity coefficient value for an ion is close to one when the solution has almost zero ionic strength, i.e., when the solution shows close to ideal behavior. As the ionic strength of the solution increases from 0 to 0.1 mol/L, a decrease in the...
Efficiency of The Carnot Cycle01:16

Efficiency of The Carnot Cycle

The hypothetical Carnot cycle consists of an ideal gas subjected to two isothermal and two adiabatic processes. Since the internal energy of an ideal gas depends only on its temperature, which is the same before and after the completion of the Carnot cycle, there is no change in its internal energy. Hence, using the first law of thermodynamics, the total heat exchanged by the ideal gas equals the total work done. Thus, we can quantify the efficiency of the Carnot cycle via the heat exchanged...
Carnot Cycle and Efficiency01:26

Carnot Cycle and Efficiency

The Second Law of Thermodynamics asserts that it's impossible for any heat engine to achieve 100% efficiency. While contemplating the maximum possible efficiency, Nicolas Sadi Carnot conceptualized an ideal heat engine. This engine gets its energy from a high-temperature reservoir. It then performs some work and releases the remaining energy into a low-temperature reservoir.The Carnot cycle, named after Sadi Carnot, is fully reversible. The cycle consists of four distinct stages. In the first...
Trophic Efficiency00:46

Trophic Efficiency

Trophic level transfer efficiency (TLTE) is a measure of the total energy transfer from one trophic level to the next. Due to extensive energy loss as metabolic heat, an average of only 10% of the original energy obtained is passed on to the next level. This pattern of energy loss severely limits the possible number of trophic levels in a food chain.
Turnover Number and Catalytic Efficiency01:19

Turnover Number and Catalytic Efficiency

The turnover number of an enzyme is the maximum number of substrate molecules it can transform per unit time. Turnover numbers for most enzymes range from 1 to 1000 molecules per second. Catalase has the known highest turnover number, capable of converting up to 2.8×106 molecules of hydrogen peroxide into water and oxygen per second. Lysozyme has the lowest known turnover number of half a molecule per second.
Chymotrypsin is a pancreatic enzyme that breaks down proteins during digestion. The...