Related Experiment Videos

Nuisances via Negativa: Adjusting for Spurious Correlations via Data Augmentation

Aahlad Puli1, Nitish Joshi1, Yoav Wald2

  • 1Department of Computer Science, New York University.

Transactions on Machine Learning Research
|October 24, 2026
PubMed

Related Concept Videos

Quantifying and Rejecting Outliers: The Grubbs Test01:02

Quantifying and Rejecting Outliers: The Grubbs Test

Sometimes, a data set can have a recorded numerical observation that greatly  deviates from the rest of the data. Assuming that the data is normally distributed, a statistical method called the Grubbs test can be used to determine whether the observation is truly an outlier.  To perform a two-tailed Grubbs test, first, calculate the absolute difference between the outlier and the mean. Then, calculate the ratio between this difference and the standard deviation of the sample. This number is...
Null and Alternative Hypotheses01:16

Null and Alternative Hypotheses

The actual hypothesis testing begins by considering two hypotheses. They are termed  the null hypothesis and the alternative hypothesis. These hypotheses contain opposing viewpoints.
The null hypothesis, denoted by H0 is a statement of no difference between the variables—they are not related. This can often be considered the status quo. As  a result if you cannot accept the null, it requires some action.
The alternative hypothesis, denoted by H1 or Ha, is a claim about the population that is...
Correlation of Experimental Data01:23

Correlation of Experimental Data

Dimensional analysis simplifies complex physical problems and guides experimental investigations, but it does not provide complete solutions. It identifies the dimensionless groups that influence a phenomenon, but experimental data is needed to establish the specific relationships and validate theoretical predictions.
For example, a spherical particle moving through a viscous fluid experiences drag. Dimensional analysis shows that the drag force depends on the particle's diameter, velocity, and...
Correlation and Causation01:27

Correlation and Causation

Correlation and CausationStatistical tests can calculate whether there is a relationship, or correlation, between independent and dependent variables. A relationship between variables shows correlation, but it does not show cause-and-effect. A direct cause-and-effect relationship requires additional controlled experiments. If no consistent relationship exists between the variables, then there is no correlation.Correlation versus CausationIf the dependent variable increases or decreases when the...
Difference from Background: Limit of Detection01:05

Difference from Background: Limit of Detection

The limit of detection (LOD) is the smallest amount of analyte that can be distinguished from the background noise. The LOD value corresponds to the concentration at which the analyte signal is three times larger than the standard deviation of the blank signal. Below this value, the analyte signal cannot be differentiated from the background noise. It is calculated by dividing the calibration slope by 3 times the standard deviation of the blank signals.
The LOD indicates the presence or absence...
Confounding in Epidemiological Studies01:27

Confounding in Epidemiological Studies

Confounding in statistical epidemiology represents a pivotal challenge, referring to the distortion in the perceived relationship between an exposure and an outcome due to the presence of a third variable, known as a confounder. This variable is associated with both the exposure and the outcome but is not a direct link in their causal chain. Its presence can lead to erroneous interpretations of the exposure's effect, either exaggerating or underestimating the true association. This phenomenon...