The properties of subunits of avidin coupled to sepharose

Avidin that had been coupled to Sepharose 4B activated with CNBr retained over 90% of its biotin-binding capacity. When low concentrations of CNBr were used about 75% of the protein could be removed from the Sepharose by washing with guanidinium chloride (6 m). The remaining 25%, the covalently bound subunits, had an almost undiminished capacity for biotin but a decreased affinity. Addition of avidin subunits in guanidinium chloride to the coupled subunits followed by dilution or dialysis restored the original biotin-binding capacity and affinity. Three classes of binding sites were present in preparations of the subunits. About 25% were weak (K=5x10(-8)m), about one third exchanged their biotin in a few minutes (K approximately 10(-10)m) and the remainder were indistinguishable from the native tetramer. The last-named exchanged their bound biotin at a similar rate at pH5 and at pH2, they did not lose their biotin in 6 m-guanidinium chloride and they were resistant to tryptic digestion in the absence of biotin. The proportion of these stable sites could be increased to 65% when the subunits coupled to Sepharose were incubated at 37 degrees C. This increase was reversed by guanidinium chloride, which suggested that it was caused by a temperature-dependent association of covalently linked subunits. This in turn implies a temperature-dependent mobility of the agarose matrix of the Sepharose. Analysis of the spatial distribution of subunits within the Sepharose beads led to the conclusion that the association of subunits implied that they could move through distances greater than 20nm (several hundred A). This mobility and consequent formation of tetramer was greatly decreased when avidin subunits were coupled to Sepharose that had been cross-linked with divinyl sulphone.