Related Experiment Video
Updated: Aug 11, 2026

A Swine Model of Neonatal Asphyxia
Published on: October 11, 2011
Some characteristics of transcutaneously monitored oxygen partial pressure in normal newborns
Abstract:
The transcutaneous oxygen partial pressure (PtcO2) was monitored in 50 healthy, normally and spontaneously delivered newborns. Measurements were performed during the first to fourth day of life. The electrode temperature was 44.5 degrees C. The mean PtcO2 level recorded during about 45 min was 9.2 kPa (S.D. 1.4) recorded from the minute-to-minute values. The PtcO2 level normally oscillated to a certain extent and the oscillations were closely related to the breathing pattern of the patient. When the patient fell asleep during measurement, the normal oscillating pattern was replaced by a "silent pattern". During crying, the PtcO2 level showed four main reaction aptterns. A decrease in the PtcO2 level could be observed during breast-feeding. One child, recently fed, vomited a small amount of breast milk after a short period of crying and apparently had a laryngospasm, shown by a sudden drop in the PtcO2 level without any other signs of discomfort. The study shows that PtcO2 (and thus also PaO2) very sensitively reacts to changes in activity. This implies that earlier used methods for determination of PaO2 might give values that are not representative for the steady state as the sampling method per se might influence the recorded PO2 value.
Related Concept Videos
Assessment of Diffusion and Perfusion
The Role of Diffusion in Respiration
Diffusion is the process by which molecules move from an area of higher concentration to an area of lower concentration. In the respiratory system, this principle...
Special considerations while measuring oxygen saturation
Ensuring accuracy in vital sign recordings while prioritizing patient comfort and minimizing anxiety is important.
Pulse Oximetry
Purpose
Average SpO2 values are greater than 95%. If the readings fall below 90%, it indicates that...
Oxygen Delivering System I: Nasal Cannula and Face Mask
Nasal Cannula
A nasal cannula is a lightweight tube split at one end into two prongs and placed in the nostrils. It is typically used to deliver low to medium levels of oxygen.
Suggested flow rate: The suggested flow rate for a nasal cannula typically ranges between 1 and 6 L/min.
Oxygen percentage setting:...
Oxygen Delivering System II: Venturi Mask and Transtracheal Oxygen
Venturi Mask
The Venturi mask, named after the Venturi effect, is designed to deliver precise oxygen concentrations. It consists of a large tube with an oxygen inlet that narrows down, causing a pressure drop that pulls air in through adjustable side ports. The mask is a lightweight,...
Oxygen Delivering System III: Tracheostomy and T-piece
Tracheostomy
A tracheostomy is a surgically created opening (stoma) in the anterior part of the trachea. It is used to establish a patient airway, bypass an upper airway obstruction, simplify the removal of secretions, permit long-term...

