Isolation and kinetic analysis of inward currents in neuroblastoma cells

The suction pipette method for combined voltage clamp and intracellular dialysis was applied to isolate the two components of voltage-gated inward current across membranes of NIE-115 neuroblastoma cells. In order to analyze the kinetic behavior of the Na+ and Ca2+ channels responsible for generating these components, current through K+ channels was effectively blocked by substituting impermeant Cs+ for internal and external K+. Block was confirmed independently by examining the effects of the application of external tetraethylammonium or Cd2+; and comparing the time course of Ca2+ tail currents with the decay of current during a maintained depolarization. Na+ currents studied at 8-10 degrees C, developed as a fourth order process giving a maximum e-fold conductance change for a 3 mV depolarization, with half activation occurring at -10 mV. The instantaneous current-voltage relationship was linear. Time constants of the activation parameter (m) varied from 0.5 ms (-50 mV) to 3-4 ms (-10 to -40 mV) at 10 degrees C. Inactivation (h) was a first order process having a time constant between 4 ms (+10 to +60 mV) and 225 ms (-60 mV). Steady-state inactivation for Na+ channels attained a value of 0.5 at -50 mV. A slow inactivation process, however, also is involved in gating of Na+ channels, and has a time course at least two orders of magnitude slower than that for h. The temperature sensitivity of Na+ currents was found to be similar to that found for other preparations. Ca2+ currents were studied at 24-29 degrees C in the presence of internal ethyleneglycolbis-(aminoethylether)-tetra-acetate (EGTA) and an external Ca2+ concentration of 20 mM. Ca2+ channel activation could also be described by a fourth order process giving an e-fold conductance change for a 5-6 mV change in potential and the half activation potential of -13 mV. Internal EGTA (20 mM) did not abolish inactivation of Ca2+ currents and no recovery from inactivation caused by a prepulse could be measured as the prepulse potential approached the null potential for Ca2+ influx. Time constants of both activation and inactivation of Ca2+ channels were measured between -20 and +50 mV. Currents through K+ channels could be completely eliminated by substitution of K+ with Cs+, although a residual non-linear leakage current remained, in addition to currents through the Na+ and Ca2+ channels.(ABSTRACT TRUNCATED AT 400 WORDS)