[Evaluation of gamma camera collimator for regional cerebral blood flow measurements using a 133Xe inhalation method]

In the measurements of regional cerebral blood flow (rCBF) using inhalation of 133Xe gas, the activity present is generally limited in lower levels than those of usual brain scintigraphy. Measurements with low count-rate are usually resulted in diminishing the accuracies of results obtained. Therefore, it is necessary to make measurements using a high sensitive collimator for getting as much count-rate as possible when a gamma camera is used. The relationships among sensitivity and structures of multi-parallel collimator were mathematically analyzed. The results of analysis suggested that sensitivity usually increased by using a collimator with holes of reduced height and diameter. A prototype multi-parallel collimator with holes of low height and small diameter was made in our laboratory for testing sensitivity and resolution. The collimator possessing 1141 holes of 6 mm phi in hole diameter, 1.5 cm is hole height and septal thickness of 1 mm lead showed 24 times more sensitive than those of a general all purpose collimator supplied by the manufacturer. However, resolution measured in FWHM was of 9 to 14 mm at the collimator face and of 29 to 38 mm at 5 cm from the face. The results indicated that this collimator was useful enough in rCBF measurements with 133Xe inhalation using a gamma camera. The mathematical analysis however, suggested that optimum collimator for rCBF measurements was approximate 4.5 mm phi in hole diameter and 1.0 cm in hole height.