Geometrical factors influencing muscle force development. I. The effect of filament spacing upon axial forces

The influence of geometry on the force and stiffness measured during muscle contraction at different sarcomere lengths is examined by using three specific models of muscle cross-bridge geometry which are based upon the double-hinge model of H. E. Huxley (Science [Wash. D.C.]. 1969, 164:1356-1366) extended to three dimensions. The force generated during muscle contraction depends upon the orientation of the individual cross-bridge force vectors and the distribution of the cross-bridges between various states. For the simplest models, in which filament separation has no effect upon cross-bridge distribution, it is shown that changes in force vectors accompanying changes in myofilament separation between sarcomere lengths 2.0 and 3.65 microgram in an intact frog skeletal muscle fiber have only a small effect upon axial force. The simplest models, therefore, produce a total axial force proportional to the overlap between the actin and myosin filaments and independent of filament separation. However, the analysis shows that it is possible to find assumptions that produce a cross-bridge model in which the axial force is not independent of filament spacing. It is also shown that for some modes of attachment of subfragment-1 (S1) to actin the azimuthal location of the actin site is important in determining the axial force. A mode of S1 attachment to actin similar to that deduced by Moore et al. (J. Mol. Biol., 1970, 50:279-294), however, exhibits rather constant cross-bridge behavior over a wide range of actin site location.