[125I]diiodoinsulins. Binding affinities, biologic potencies, and properties of their decay products

Insulin was iodinated with 0.3-0.4 mol 125I/mol insulin using the lactoperoxidase method. About one-third of the radioactivity incorporated into insulin was in diiodoinsulins and about 40% of these molecules contained diiodotyrosine in residue 14 of the A chain. Most of the remaining molecules contained one A14-monoiodotyrosine and one monoiodotyrosine in either position A19, B16, or B26. The binding affinity and biologic potency of this heterogeneous diiodoinsulin preparation was not significantly different from that of A14-[125I]monoiodoinsulin in rat adipocytes, whereas it was slightly reduced in hepatocytes and IM-9 lymphocytes. From the iodine distribution and previous data on the binding affinity of each of the four monoiodoinsulin isomers it was calculated that A14-diiodotyrosine-insulin possesses full binding affinity and biologic potency in adipocytes. Diiodoinsulins isolated from another iodoinsulin preparation (iodate method) contained 58% A19-diiodotyrosine-insulin, and most remaining molecules contained one A19-monoiodotyrosine. The binding affinity of this mixed diiodoinsulin preparation was approximately one-fourth of that of A14-monoiodoinsulin in adipocytes, IM-9 lymphocytes, and hepatocytes. It was calculated that A19-diiodotyrosine-insulin is nearly devoid of binding affinity. The diiodoinsulins (lactoperoxidase method) decayed to iodide (probably from diiodotyrosine-insulin) or to polymers with little specific but a markedly increased nonspecific binding. In addition, the polymers had a marked tendency to adsorb to cellulose acetate filters.

1. The binding affinities of diiodoinsulins range from very low values to values at least as high as that of insulin depending on the positions of the iodine moieties. 2. The relative binding affinities vary among tissues. 3. Polymeric decay products give high nonspecific binding.