Citric acid demineralization of cementum and dentin: the effect of application pressure

Previous work has shown that a 25-30% citric acid solution was the most effective concentration with which to demineralize dentin. The purpose of this investigation was to study the topography, using a scanning electron microscope, of root surfaces treated with a 30% citric acid solution using various application pressures. 20 freshly extracted human teeth were collected and stored in physiologic saline at room temperature. 3 root specimens, approximately 3x5x5 mm in size, were prepared from the coronal periodontally healthy area of each tooth. 30 specimens were root planed to expose dentin (dentin group) while the remaining 30 specimens were lightly scaled to remove periodontal soft tissue (cementum group). A freshly made 30% citric acid (CA) solution, (pH = 1.60), was applied to each of the experimental areas. Cotton pellets soaked in the citric acid solution were either placed (CAP), lightly rubbed (CAR) or heavily burnished (CAB) on the prepared root surface for 3 min. Pellets were resoaked every 30 s. The root sections were rinsed, fixed in glutaraldehyde, dehydrated in graded ethanol, critically point dried in liquid CO2 and sputter coated in gold. The treated surfaces were assessed for fibril tufting using scanning electron microscopy. Assessment was made of: (i) the % of surface area tufted; (ii) tufting depth (0-3); (iii) tufting density (1-3). Results of the study showed significantly more tufted surface area and greater tufting depth on both dentin and cementum for CAR and CAB compared to CAP. CAP produced a flat/mat fibril surface with no evidence of tufting.(ABSTRACT TRUNCATED AT 250 WORDS)