Proline in a transmembrane helix compensates for cavities in the photosynthetic reaction center

A site-specific double mutant, in which the large aromatic residues M208Tyr and L181Phe in the interior of the photosynthetic reaction center (RC) complex were replaced by smaller threonine residues, showed a dramatic reduction in the number of assembled complexes and was incapable of photosynthetic growth. The cavity created by the smaller side-chains was thought to interfere with the stability and/or assembly of the complex. Phenotypic revertants were recovered in which a spontaneous second-site mutation restored photocompetence in the presence of the original site-specific mutations. In these strains, an Ala-->Pro substitution in a neighboring transmembrane helix (at M271) resulted in an increased yield of RC complexes. To test the hypothesis that the original phenotype was due to a cavity, other mutants were constructed that created similar-sized voids at other positions in the membrane-spanning interior. These substitutions caused the same phenotype. Coupling of the above proline substitution to these new cavity mutants also resulted in photocompetent strains that carry increased levels of RC complexes. Therefore, the proline substitution at M271 serves as a global suppressor of the phenotype caused by these internal cavities. The proline substitution slightly increases the thermal stability of the complex at higher temperatures, but the mutant and suppressor strains have about the same stability at the optimal culture temperature, where both are less stable than the wild-type strain. Therefore, the proline substitution may suppress the non-photosynthetic phenotype of cavity mutants by facilitating folding of the nascent polypeptides as they assemble with cofactors to form the transmembranar RC complex. The proline replacement occurs at a pre-existing kink in a transmembrane helix where it can be accommodated without introducing a strain in the structure. The function of proline residues in transmembrane helices might be to promote folding and/or assembly in general.