Determination of radiation energy emitted by light activation units

Since the introduction in the 1970s of single paste composite materials, there has been a rapid increase in the range of both materials and activation light units. This investigation is being undertaken as part of a larger study where the characteristics of both composite materials, light activation units and composite material/light activation unit combinations, are being evaluated. This section of the study was undertaken to determine the characteristics of four light activation units. The equipment was developed to measure radiation energy over a wide range of illumination. This range can be from the relatively low intensity of radiation transmitted through restorative materials to the intensities of direct radiation from light activation units. The four light units tested had various radiation outputs between 225,000 lx and 75,000 lx. All the units, apart from one, showed a decrease in light output with successive applications. The units emitted radiation outside the optimum range of 440-500 nm, which may produce damaging radiation and glare. Although the extreme intensities varied threefold the effect on depth of cure of one-material varied by only 16%.