Related Experiment Video

Updated: Jul 28, 2026

Silicon Microchips for Manipulating Cell-cell Interaction
23:21

Silicon Microchips for Manipulating Cell-cell Interaction

Published on: August 30, 2007

The "turn-up" plasty: one solution to a complex problem

R G Tronzo, A M Janek

    Orthopedic Nursing
    |May 1, 1995
    PubMed

    More Related Videos

    Process of Making Three-dimensional Microstructures using Vaporization of a Sacrificial Component08:31

    Process of Making Three-dimensional Microstructures using Vaporization of a Sacrificial Component

    Published on: November 2, 2013

    Treatment of Facial Deformities using 3D Planning and Printing of Patient-Specific Implants07:11

    Treatment of Facial Deformities using 3D Planning and Printing of Patient-Specific Implants

    Published on: May 23, 2020

    Related Concept Videos

    Plasticity00:58

    Plasticity

    Plasticity is the property where an object loses its elasticity and undergoes irreversible deformation, even after the deformation forces are eliminated. If a material deforms irreversibly without increasing stress or load, then this is called ideal plasticity. For example, when a force is applied to an aluminum rod, it changes its shape, but it does not return to its original shape once the force is removed. Plastic deformation or ductility is thus a permanent deformation or change in the...
    Method of Joints: Problem Solving II01:30

    Method of Joints: Problem Solving II

    Consider a truss structure with frictionless joints fixed to a wall and roller support. If a force of 150 N is applied to joint A, the forces in each member of the truss can be determined using the method of joints.
    Problem-Solving: Tuning of a Guitar String01:04

    Problem-Solving: Tuning of a Guitar String

    In the case of stringed instruments like the guitar, the elastic property that determines the speed of the sound produced is its linear mass density or the mass per unit length. This is simply called the linear density. If the string's linear density is constant along the string, then the linear density is simply the total mass divided by the total length.
    The string's wave speed can be regulated by varying the linear density. Tension is the other property that determines the speed of...
    Angle of Twist: Problem Solving01:13

    Angle of Twist: Problem Solving

    An electric motor applies a torque of 700 N·m to an aluminum shaft, triggering a stable rotation. Two pulleys, B and C, are subjected to torques of 300 N·m and 400 N·m, respectively. The modulus of rigidity is provided as 25 GPa. With the knowledge of the length and diameter of each segment, the twist angle between the two pulleys can be computed. First, a section cut is made between pulleys B and C, and the cut cross-section is analyzed using a free-body diagram. Given that the torque exerted...
    Plastic Deformations01:14

    Plastic Deformations

    It is essential to understand how structural members behave under plastic deformation when the bending stress exceeds the material's yield strength. This state of deformation permanently alters the shape of the member, in contrast to the linear elastic behavior observed before yielding. The strain at any point in the member is expressed in terms of maximum strain. Notably, the neutral axis, which coincides with the centroid during elastic bending, shifts away from the centroid under plastic...
    Plastic Deformations01:19

    Plastic Deformations

    Plastic deformation represents a fundamental concept in materials science, which explains the irreversible change in the shape of a material when it experiences stress beyond its elastic capability. This phenomenon is important in structural engineering, especially in designing and analyzing cantilever beams—structures that are securely fixed at one end and bear loads at the opposite end. When these beams are subjected to loads within their elastic range, they will return to their original...