Related Experiment Videos
Comparison of polycarbonate and steel test surfaces for videokeratography
R J Potvin1, D Fonn, L Sorbara
1Centre for Contact Lens Research, University of Waterloo, Ontario, Canada.
Background:
Assessing video imaging systems for measuring corneal topography often requires test surfaces. Steel bearings have been employed, but manufacturers caution that high reflectance (> 90%) relative to the eye (< 10%) may compromise test findings. The differences between steel and polycarbonate test surfaces are quantified in this study.
Methods:
Images of a steel and a polycarbonate sphere of known radius of curvature were obtained with the Tomey/Computed Anatomy Topographic Modeling System (TMS, Cambridge, Mass). Analysis was performed on the raw video data files and the resultant surface curvature estimates.
Results:
The raw video images differed sufficiently to affect image processing. Polycarbonate yielded consistently better images. Many steel images (approximately 25%) contained data points that could not be processed; calculated surface contour was more variable for these. Differences were less obvious when these images were removed from the pool.
Conclusions:
Results support the manufacturer's caution against the use of steel surfaces for testing or calibration of the TMS instrument. Problems appear due to the fundamental differences in the intensity distributions of video images captured from high- and low-reflectance surfaces.