Looking for guarantees

Related Concept Videos

Reliability and Validity01:29

Reliability and Validity

Reliability and validity are two important considerations that must be made with any type of data collection. Reliability refers to the ability to consistently produce a given result. In the context of psychological research, this would mean that any instruments or tools used to collect data do so in consistent, reproducible ways.
Confirmation Biases01:31

Confirmation Biases

The confirmation bias is the tendency to focus on information that confirms our existing beliefs and ignore information that is inconsistent with our expectations. For example, if you think that your professor is not very nice, you notice all of the instances of rude behavior exhibited by the professor while ignoring the countless pleasant interactions he is involved in on a daily basis. Have you ever fallen prey to the confirmation bias, either as the source or target of such bias?
Interpretation of Confidence Intervals01:19

Interpretation of Confidence Intervals

A confidence interval is a better estimate of the population than a point estimate, as it uses a range of values from a sample instead of a single value.
Confidence intervals have confidence coefficients that are crucial for their interpretation. The most common confidence coefficients are 0.90, 0.95, and 0.99, which can be written as percentages–90%, 95%, and 99%, respectively.
Suppose a person calculates a confidence interval with a confidence coefficient of 0.95. In that case, they can...
Conditions of Equilibrium01:28

Conditions of Equilibrium

Equilibrium refers to a state where a rigid body is not subjected to any translational or rotational motion. This state is achieved when the force and couple acting on a rigid body equal zero. When the system of external forces results in a net effect equivalent to zero, the rigid body is considered to be in equilibrium.
Internal forces are not considered for conditions of equilibrium because they occur in equal and opposite pairs within the body, effectively canceling each other. As a result,...
Constraints and Statical Determinacy01:26

Constraints and Statical Determinacy

In structural engineering, the equilibrium of a system is not only determined by its equations of equilibrium but also with the help of constraints. Constraints refer to restrictions on the motion of a system. The proper combinations of constraints can minimize the total number of constraints needed to maintain a system in mechanical equilibrium. When this happens, the system is said to be statically determinate. For such systems, the unknown reaction supports can be estimated using equilibrium...
Quality Assurance01:19

Quality Assurance

Quality assurance is the overarching term used to describe the activities employed to ensure the proper performance of a system. These activities can be classified into three categories: quality control, quality assessment, and internal corrective measures. Typically, these activities work cyclically: quality control is performed before and during the analysis, while quality assessment occurs during and after the investigation. Internal corrective measures are implemented based on the findings...