Electrical properties of cell pellets and cell electrofusion in a centrifuge

A new approach is proposed for studying cell deformability by centrifugal force, electrical properties of cell membranes in a high electric field, and for performing efficient cell electrofusion. Suspensions of cells (L929 and four other cell types examined) are centrifuged in special chambers, thus forming compact cell pellets in the gap between the electrodes. The setup allows measurement of the pellet resistance and also the high-voltage pulse application during centrifugation. The pellet resistance increases sharply with the centripetal acceleration, which correlates with reduction of the cell pellet porosity due to cell compression and deformation. Experiments with cells pretreated with cytochalasin B or colcemid showed that cell deformability depends significantly on the state of cytoskeleton. When the voltage applied to the cell pellet exceeds a 'critical' value, electrical breakdown (poration) of cell membranes occurs. This is seen as a deflection in the I(V) curve for the cell pellet. The electropores formed during the breakdown reseal in several stages: the fastest takes 0.5-1 ms while the whole process completes in minutes. A novel effect of colloid-osmotic compression of cell pellets after electric cell permeabilization is described. Supercritical pulse application to the cell pellet during intensive centrifugation leads to massive cell fusion. The fusion index grows with the increase of centripetal acceleration, and drops drastically when the pulse is applied after the centrifuge is stopped. The colloid-osmotic pellet compression enhances the fusion efficiency. No fusion occurs when cells are brought in contact after the pulse treatment. The data suggest that tight intermembrane contact formed prior to pulse application is a prerequisite condition for efficient cell electrofusion. The capacities of the technique proposed and the mechanism of membrane electrofusion are discussed.