Gas chromatographic/nitrogen-phosphorus detection method for determination of ethylene thiourea in finished drinking...

A joint U.S. Environmental Protection Agency (USEPA)-AOAC interlaboratory method validation study was conducted on USEPA National Pesticide Survey (NPS) Method 6, "Determination of Ethylene Thiourea (ETU) in Finished Drinking Water by Gas Chromatography with a Nitrogen-Phosphorus Detector." The purpose of the study was to determine and compare the mean recoveries and precision for determination of ETU in reagent water and finished drinking waters. The study design was based on Youden's nonreplicate plan for collaborative tests of analytical methods. The waters were spiked with ETU at 6 concentrations levels, prepared as 3 Youden pairs. In the method, the test water is extracted by passing the sample through an absorbent matrix type tube. ETU is recovered from the tube with methylene chloride, the extract is solvent-exchanged to ethyl acetate, and an aliquot of each extract is analyzed by gas chromatography using a nitrogen-phosphorus detector. Twelve laboratories participated in the study. Data were analyzed using a USEPA computer program, which measured recovery and precision for ETU and compared the performance of the method between the 2 water types. Over the concentration range tested, the mean percent recoveries of ETU were 82-92% in reagent water and 85-98% in finished drinking water. The range of the between-laboratory relative standard deviations (RSDR) for the 6 concentrations was 5-24% in reagent water, but was only 4-9% in finished drinking water. The range of the within-laboratory relative standard deviations (RSDr) was 6-14% for reagent water and 6-10% for finished drinking water. Results for the 2 water matrixes showed no statistically significant differences.(ABSTRACT TRUNCATED AT 250 WORDS)