Load-bearing capacity of corticocancellous bone grafts in the spine

We investigated the relationship between the densities and areas of commonly used autogenous tricortical bone grafts from the iliac crest and the fibula and their mechanical load-bearing abilities. Intact corticocancellous grafts, seven millimeters thick, were obtained during elective spinal arthrodeses from fifty-six patients: from the anterior part of the pelvis in twenty-four patients, the posterior part of the pelvis in twenty-nine patients, and the fibula in three patients. The apparent densities and cross-sectional areas of the cortical and cancellous bone were measured with use of a specific computed-tomographic technique before the specimens were mechanically tested to failure in uniaxial compression. Specimens from the anterior superior iliac spine were able to bear significantly higher axial loads (average, 3230 newtons; range, 430 to 8112 newtons) than were those from the posterior superior iliac spine (average, 1458 newtons; range, 350 to 4639 newtons) (p < 0.001). The cancellous density was the most significant single factor in the prediction of the load to failure of the grafts from the iliac crest (adjusted r2 = 0.58; p < 0.0001). When all of the physical variables (the cancellous and cortical densities and areas) were entered into a multiple-regression model, the combination of the cortical and cancellous densities and the cortical area was a good predictor (adjusted r2 = 0.68; p < 0.001) of the load to failure. The fibular grafts were stronger than those from the other two sites, but they had the least over-all cross-sectional area and cancellous bone.(ABSTRACT TRUNCATED AT 250 WORDS)