Fixation strengths of patellar tendon-bone grafts

Secure fixation of bone-patellar tendon-bone grafts is essential to allow early joint mobilization after anterior cruciate ligament (ACL) reconstruction surgery. This study was designed to evaluate four fixation methods of patellar tendon-bone grafts in cadaveric knees. Fifty-one fresh cadaveric patellar tendon-bone specimens were anchored in tibial or femoral metaphyseal bone tunnels. Group I grafts were fixed with Kurosaka interference screws. In Group II the grafts were initially fixed as in Group I, but the screws were then removed, the bone plugs repositioned, and the grafts resecured with screws. In Group III the grafts were anchored with three no. 2 nonabsorbable sutures tied over a screw and washer, whereas in Group IV no. 5 nonabsorbable sutures were used. Each bone specimen was mounted in the biomechanical testing machine, and a vertical tensile load was applied at a strain rate of 51 cm/min until failure of fixation, bone plug fracture, or tendon disruption occurred. The mean force to failure in Groups I, II, III, and IV were 435.0 N, 458.2 N, 454.2 N, and 415.8 N, respectively. There was no significant difference in the force to failure among the four methods of fixation. However, the modes of failure were diverse. In three specimens the Kurosaka screws diverged from the plugs and failed to achieve fixation. These specimens were excluded and will be discussed separately. Although technique-related difficulties may arise, interference screw fixation of patellar tendon-bone grafts affords strong graft fixation--often stronger than the graft itself. Secondary screw fixation appears to be equal in strength to primary screw fixation.(ABSTRACT TRUNCATED AT 250 WORDS)