Exposure to asbestos fibres during gasket removal

In the chemical industry, asbestos gaskets have been used extensively to prevent leakage between solid surfaces. The purpose of this study was to assess the potential personal exposure to asbestos fibres during gasket removal and thus to determine what is reasonably required in terms of protective regime and work method. Two groups were studied: group A, who only removed gaskets if they could be removed easily and without breaking; and group B, who removed gaskets which were left by the first group. For both groups, the gasket was first made wet before removal. The samples were analysed using phase-contrast microscopy and transmission electron microscopy. The average exposure to fibres for group A, averaged over the work period, was 0.04-0.242 fibres ml-1 as determined by phase-contrast microscopy. On further analysis with transmission electron microscopy it was found that only four of the 11 samples contained asbestos in very low concentrations and that most of the fibres, which were identified using phase-contrast microscopy, probably originated from the glass fibre lagging around the pipes. For group B the average fibre concentration, averaged over the work period, as determined by phase-contrast microscopy, ranged between below the detection limit and 0.02 fibres ml-1. The subsequent transmission electron microscopy analysis shows that the exposure to asbestos fibres ranged between below the limit of detection to 0.004 fibres ml-1. This study shows that the exposure to asbestos fibres during gasket removal activities was well within the 8-h average exposure limit of 0.3 fibres ml-1.