Related Experiment Video
Updated: Aug 11, 2026

A Cognitive Paradigm to Investigate Interference in Working Memory by Distractions and Interruptions
Published on: July 16, 2015
Detectability of simultaneously masked signals as a function of masker bandwidth and configuration for different
1Keck Center, University of California at San Francisco 94143-0732, USA.
Abstract:
Signal detectability was measured in three temporal conditions as a function of the bandwidth and configuration of simultaneous maskers that either did or did not spectrally overlap the signal. The 20-ms signal was 250 Hz wide and was centered at 2500 Hz (fs). Although there were marked individual differences, performance was typically poorer when signal onset came 1 ms rather than 250 ms after the onset of a 420-ms masker, and poorest when signal onset came 1 ms after the onset of a 23-ms masker. The results support the idea that two separate across-channel processes contribute to temporal changes in signal detectability. One process contributes to the improvement observed as signal onset is delayed from masker onset, and its influence is reduced by the presence of masking components at fs only when the masker extends exclusively below fs. The other process is associated with the improvement observed as masker offset is delayed from signal offset, and its influence is reduced by the presence of masking components at fs when the masker extends exclusively above, or both below and above fs. Both of these processes are primarily activated by frequencies ranging from 0.6 to 0.8fs and 1.2 to 1.4fs. The data also demonstrate that the measured critical bandwidth narrows as signal onset is delayed from masker onset.
Related Concept Videos
Interference: Path Lengths
Two special sources may be considered when they are in phase. This can be easily achieved by feeding the two sources from the same source. An example would be synchronizing the two speakers by feeding them with the same source, such as the sound waves produced by a tuning fork. This setup ensures that the two sources have the same frequency and are...
Design Example
Properties of DTFT I
The linearity property of DTFTs is fundamental. If two discrete-time signals are multiplied by constants a and b respectively, and then combined to...
Sampling Theorem
Aliasing
If the sampling frequency is below the Nyquist rate, these replicas overlap, preventing the original signal...
Bandpass Sampling
A bandpass signal has a spectrum with a lower frequency limit, denoted as ω1, and an upper frequency limit, denoted as ω2. The spectrum...

