Alveolar breath sampling and analysis to assess exposures to methyl tertiary butyl ether (MTBE) during motor vehicle...

Methyl tertiary butyl ether (MTBE) is added to gasoline (15% by volume) in many areas of the U.S. to help control carbon monoxide emissions from motor vehicles. In this study we present a sampling and analytical methodology that can be used to assess consumers' exposures to MTBE that may result from routine vehicle refueling operations. The method is based on the collection of alveolar breath samples using evacuated one-liter stainless steel canisters and analysis using a gas chromatograph-mass spectrometer equipped with a patented "valveless" cryogenic preconcentrator. To demonstrate the utility of this approach, a series of breath samples was collected from two individuals (the person pumping the fuel and a nearby observer) immediately before and for 64 min after a vehicle was refueled with premium grade gasoline. Results demonstrate low levels of MTBE in both subjects' breaths before refueling, and levels that increased by a factor of 35 to 100 after the exposure. Breath elimination models fitted to the post exposure measurements indicate that the half-life of MTBE in the first physiological compartment was between 1.3 and 2.9 min. Analysis of the resulting models suggests that breath elimination of MTBE during the 64 min monitoring period was approximately 115 micrograms for the refueling subject while it was only 30 micrograms for the nearby observer. This analysis also shows that the post exposure breath elimination of other gasoline constituents was consistent with previously published observations. These results demonstrate that this new methodology can be used effectively in studies designed to assess exposures to MTBE. The method can be used to objectively demonstrate recent exposures, the relative magnitude of an exposure, and the approximate duration of the resulting bloodborne dose. Once a blood/breath partition coefficient for MTBE has been firmly established, the bloodborne concentration of the absorbed material can be determined using these techniques as well.